Справочник Пользователя для Polycom C12

 Installing The SoundStructure C16, C12, C8, And SR12

2 - 11

the device with no OBAM OUT connection. The device ID is important for 

ensuring that a system is cabled properly so that it matches the configuration 

that will be uploaded to the system.
As an example, consider the following figure that shows a SoundStructure C12 

linked with a C8. 

The SoundStructure Studio software can be used to create a design that will be 

uploaded into the devices. In this example, the configuration file requires 

devices to be linked together with the C12 as the first device (device ID 1) and 

the C8 as the second device (device ID 2). The wiring report summarizes the 

cabling connections for the input and output signals. A typical wiring report 

generated for the SoundStructure devices is shown in the following text.
This wiring report shows the signal connections to both the SoundStructure 

C12 at device ID 1, and the SoundStructure C8 at device ID 2. The report also 

indicates a telephony interface is plugged into the C12 and a Polycom HDX 

video codec is connected via the C-Link2 interface to the C12. This report also 

summarizes how the individual inputs and outputs should be connected to 

the rear-panel of the SoundStructure devices, for instance Table Mic 1 should 

be connected to input 1 on the SoundStructure C12.

SoundStructure system: New SoundStructure

C12 (bus id: 1)

C-Series Mic Input

 1: Table Mic 1

 2: Table Mic 2

 3: Table Mic 3

 4: Table Mic 4

 5: Table Mic 5

 6: Table Mic 6

 7: Table Mic 7

 8: Table Mic 8

 9: Table Mic 9

 10: Table Mic 10

 11: Table Mic 11

 12: Table Mic 12

C-Series Line Output

 1: Amplifier 1 (Left)

 2: Amplifier 1 (Right)

 3: Amplifier 2 (Left)

IN

OUT

SoundStructure   C8

TM

12V

IN

OUT

SoundStructure   C12

TM

12V

PHONE

LINE