Справочник Пользователя для Toshiba SD-V390-S-TU

z

Depending on your TV and other equipment you wish to
connect, there are various ways you could connect the
DVD+VCR. Use connections described on pages 11-14.

z

Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the best
connections.

z

For better sound reproduction, connect the DVD+VCR’s
DVD/VHS AUDIO OUT jack to the audio in jacks of your
amplifier, receiver, stereo or audio/video equipment. See
Optional, Preferred TV Connections on page 13-14.

z

Make sure the DVD+VCR is connected directly to the TV.
Tune the TV to the correct video input channel.

z

Do not connect the DVD+VCR’s DVD/VHS AUDIO OUT
jack to the phono in jack (record deck) of your audio 
system.

z

Do not connect your DVD+VCR via your VCR. The DVD
image could be distorted by the copy protection system. 

1

Disconnect the antenna leads from the rear of the
TV.

2

Identify the type of cable from your antenna. If it is
a round cable as illustrated, it is a 75 ohm coaxial
antenna cable. This cable will connect directly to
the jack marked ANT.IN on your DVD+VCR.

If your antenna lead wire is a flat type antenna cable,
connect it to a Antenna Adaptor (300-ohm to 75-ohm)
(not supplied) and slip the Adaptor onto the ANT.IN 
jack. The Adaptor does not screw on to the DVD+VCR,
it just slips over the jack.

If your cable wire is connected to your TV without a converter
or descrambler box, unscrew the wire from your TV and attach
it to the ANT.IN jack on the DVD+VCR. Use the supplied round
coaxial cable to connect between the DVD+VCR’s RF.OUT
jack and the 75 ohm antenna input jack on the TV. With this
connection, you can receive all midband, super band, and
hyperband channels.

If a converter is required in your cable system, follow the
instruction below:
The cable hookup permits both TV and DVD+VCR operation. 
To view or record CATV channel
1 Tune the TV to the DVD+VCR output channel (CH 3 or 4).
2 Set the DVD+VCR channel selector to the output channel of

the Cable Converter box by pressing the CH/TRK (+/-) or
number (0-9) of your DVD+VCR. (Example: CH3)

3 Select the channel to view at the Cable Converter Box.

z

With this connection, you CANNOT record one program
while viewing another.

z

If you are using a cable box to tune channels, it is not nec-
essary to do Auto Channel Programming(Auto Channel Set)
as indicated on page 16.

Flat Wire

(300 ohm)

300/75 ohm

Adaptor

(Not supplied)