Справочник Пользователя для Samson L615

ENGLISH

5

1.     Enclosure – Rigid, all-plywood enclosure for maxmum 

output and durability. 

2.   Handle – Oversize carry handle.
3.   Bass Port– Precision tuned, low frequency port 

extends the bass response. 

4.   Steel Grill – Durable steel grill provides protection
5.   Low Frequency Driver -  12-inch woofer with oversize 

motor and 3-inch voice coil deliver deep, controlled 

bass response.

6.   Power LED – Blue Light Emitting Diode illuminates 

indicating the unit is powered on and ready for 

operation. 

7   Titanium Compression Driver – 1.75 inch (44mm), 

titanium diaphragm with 1 inch opening. 

8.   Wide Dispersion Horn  – 1 inch throat, 60 x 90 degree 

wide dispersion horn provides extensive coverage and 

linear off- axis response.

Amplifier Panel Rear View
9.   AC Power inlet  / Fuse Sled – Connect the supplied 

standard IEC AC power cable here.

10.   VOLTAGE switch - Used to change the operating 

voltage from 115 to 230 volts.  

IMPORTANT NOTE! Bure sure to confirm and install the 

properly rated fuse when changing the operating voltage. 

(See above AC Power Inlet).
11.  POWER – Switches on the L612Ms main power.
12.   Heat sink - Convection cooling of the internal power  

amplifier via massive aluminum extrusion. 

Amplifier Panel Side Viewv
13.   AMP / CLIP LED - Dual color LED lights Green when 

amp is active, flashes Red when the amp is clipped or 

stays Red indicating the amplifier is in protect mode.

14.    LINE LEVEL – Used to control the level of the line 

input.

15.   LOW  FREQUENCY - Controls the low band of the 

Channel Equalizer, +/- 12 dB at 100Hz.

16.   HIGH FREQUENCY - Controls the high band of the 

Channel Equalizer, +/- 12 dB at 10kHz.

17.   LINE INPUT connector - XLR Input for connecting 

balanced line level signals.

18.   LINE OUTPUT connector- Male XLR connector used 

to link multiple L612M’s.