Справочник Пользователя для 3M C1060

Model C1060 Headset Intercom System 

©3M  2005 November 

 

13 

 

Service Procedures (continued) 

 

 

Tools Required: 
 
1 – Number 0 Phillips Screwdriver 

1 – Soldering iron. 

 
Procedures: 
 
1.  Make sure power is off and remove Battery. 

2.  Remove two screws and Cover.  (If replacing 

old style Battery Contacts, discard all Battery 
Holder parts, they are not compatible with 
newer Battery Holder parts.) 

3.  Unsolder the two Battery Holder PWA wires. 

4.  Insert the Headband wires through the holes 

from the back side of the replacement Battery 

Holder PWA.  Solder the RED wire to the 

 

connection point and the BLACK wire to the 

 connection point. 

 

5.  Press the Battery Latch Spring onto the top 

peg of the Battery Latch.  Insert the Latch with 
Spring down through the top of the Base as 
shown.  The beveled bottom edge of the Latch 
MUST face the battery. 

6.  Press the top of the Spring into the small 

molded ribs located inside the top of the Base. 

7.  Insert the Battery Latch Button through the 

front of BOTH the Base and Latch.  Squeeze 
the parts until they snap securely together. 

8.  Press the Battery Holder PWA onto the pegs 

of the Base noting that one hole is larger than 
the other. 

9.  Place the hole in the Headband over the 

retaining peg in the Cover.  Route the power 
wires between the two posts near the top and 
the three posts near the bottom as shown.  Be 
careful to avoid pinching wires while 
replacing Cover and two screws. 

10.  Install new Headband Pad on Battery Holder 

Cover.