Справочник Пользователя для Kenwood KDC-PS907

• VOL. buttons

Press the u button to turn the volume up.

Press the d button to turn the volume down.

• TUNER button

Selects the tuner mode. Pressing this button again selects the
standby mode.

• CD button

Selects the CD mode.

• CD•MD CH button

Selects the disc changer mode. When two disc changers are
connected to the unit, the disc changer mode will be split into
disc changer mode 1 and disc changer mode 2, and each press

• Number/ letter entry buttons

Press buttons #1-6 to recall preset stations.
During direct access tuning, use these buttons to input the
frequency of the station.
Use to enter letters (alphabetical) during station name preset.

• TUNE buttons

Press the TUNE

–

button to make decreasing seeks (using the

preset tuning mode).
Press the TUNE

+

button to make increasing seeks (using the

preset tuning mode).
Use to move the cursor left or right during station name input.

• AM/FM button

Press the AM button to select the AM band.
Press the FM button to select and switch between FM1, FM2,
and FM3 bands.
During station name input, selects digits and symbols.

• DIRECT/OK button

Selects the direct access tuning mode, used to input
frequencies directly. Press this button again to cancel the mode
while it is operating.
During station name input, stores the already input data in
memory and ends the input mode.
During Station name preset play mode, selects station.

• DNPP button

Enters and cancels the Station Name Preset Play mode.

Do not set the remote on hot places such as above the
dashboard.

Use one lithium battery (CR2025).
Remove the case following the instructions as illustrated.

Insert the battery with the 

+

and 

–

poles aligned properly,

following the illustration inside the case.

Store unused lithium batteries out of the reach of children.
Contact a doctor immediately if the battery is accidentally
swallowed.

2WARNING

2CAUTION

2

1

To open

1 Keep on slide

2 Pull out.

of this button switches between them.

The KCA-S200, which is sold separately, must be used when two
disc changer units are connected.
When the KDC-C810 is the directly connected disc changer (disc
changer 1), two units may be controlled even without the KCA-
S200.