Справочник Пользователя для Kenwood KDC-PS907

Adjust the frequency to the station whose name you want to
enter. 

Press the NAME.S button for at least two seconds.
“NAME SET” is displayed once the station name preset mode
is entered.
The cursor will blink in the position where letters are entered.

Press either the 

4 or ¢ button to move the cursor to the

desired position.
The 

4 button moves the cursor to the left, and the ¢

button to the right.
You can also move the cursor left or right by pressing the 

4

or 

¢ buttons, respectively, on the remote.

Press the FM or AM button to display the desired character.
Besides the alphabet (capital letters only) and numerals, you
can choose the following characters: /, 

+

, 

–

, *, =, <, >, [ and ].

Direct Input

Direct input can made of letters (alphabetical) with the letter
entry buttons on the remote.
Example: Use the following table to enter the name "DANCE".

Continue steps 3 and 4 until all the characters are chosen for
the name.

You can enter up to 8 characters for each name.

• Assigning Names

Press the NAME.S button on the unit or the OK button on the
remote.
The name of the station is stored in memory, and the Station
Name Preset mode ends.

• Assigning Name and Storing Frequency with Station Preset

Memory
Hold down the desired preset button for at least two
seconds.
The name of the station is stored and the frequency for the
current station is stored in the selected preset button. The
Station Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.

• You can assign names to up to 25 FM stations and 8 AM

stations. If you try to enter more than that, the station name
stored the earliest will be the first one erased.
However, the station names stored in the preset button will be
retained in the memory preferentially.

• All the station names will be erased if you press the RESET

button.

• If you want to change the name of a station, first display the

name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.

• You cannot assign names to RBDS stations.

#3

1

“D”

1

“A”

#2

#6

“N”

2

#2

3

“C”

#3

“E”

2