Справочник Пользователя для JL Audio SB-J-GRCHER/10W1v2/GA2
Sheet SKU#011129 Revision 8/15/00
SB-J-GRCHER, JL AUDIO, Inc 1997 • Page 3
STEP 13: While one person holds the Stealthbox in place inside the truck, bolt the enclosure into place from
underneath using the supplied hardware. Before tightening the bolts, apply a bead of silicone sealant between
the flat washer and the vehicle's floor pan. Once this is done, tighten the bolts evenly. See diagram below.
underneath using the supplied hardware. Before tightening the bolts, apply a bead of silicone sealant between
the flat washer and the vehicle's floor pan. Once this is done, tighten the bolts evenly. See diagram below.
10369 N. Commerce Pkwy, Miramar, Florida 33025-3921 Voice: (954) 443-1100 Fax: (954) 443-1111
3/8" Bolt
Split Lock Washer
Flat Washer
Car's Sheet Metal
Enclosure Wall (fiberglass)
Threaded Insert
Molded into
Enclosure
Molded into
Enclosure
Factory Carpet
and Padding
and Padding
Supplied Hardware:
(2) 4" Sheet Wax Squares
(2) 3/8" x 1 1/4" Bolts
(2) Flat Washers
(2) Split Lock Washers
(2) 3/8" x 1 1/4" Bolts
(2) Flat Washers
(2) Split Lock Washers
Finished Installation
Specifications:
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: JL AUDIO 10W1-4 subwoofer
Cont. Power Handling: 125 W
Nominal Impedance: 4
Driver Type: JL AUDIO 10W1-4 subwoofer
Cont. Power Handling: 125 W
Nominal Impedance: 4
Ω
IMPORTANT! Once the bolts are tightened, spray undercoating onto the bolt heads to prevent rust,
leaks and loosening of the bolts over time. Failure to do so may result in corrosion and could present a
safety hazard!
leaks and loosening of the bolts over time. Failure to do so may result in corrosion and could present a
safety hazard!