Справочник Пользователя для Hifionics GLX1000.1D
INPUT OUTPUT INPUT LEVEL
PHASE REMOTE BASS EQ SONIC LOW P
ASS
L
L
R
R
SUB
POWER
PROTECT
BALANCED
9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz
SPEAKER OUTPUT
- - + +
GND REM BA
TT+12V
POWER INPUT
FUSE
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE
VIA FUSE
MONO
SUBWOOFER
1-OHM MINIMUM
POWER INPUT
GND REM BA
TT+12V
CH 1/2 SPEAKER OUTPUT CH 3/4
RIGHT LEFT
RIGHT LEFT
- + - + - + - +
BRIDGED
BRIDGED
FUSE
LINE INPUT
REMOTE
POWER
PROTECT
LINE OUT
HI FULL
LP/BP
HI FULL
LP/BP
6V 0.2V
10Hz-15KHz
30Hz-150Hz
0dB-10dB
HI P
ASS
LOW P
ASS
BASS EQ
LEVEL
X-OVER
1
/2 CH
6V 0.2V
10Hz-15KHz
30Hz-150Hz
0dB-10dB
X-OVER 3
/4 CH
HI P
ASS
LOW P
ASS
BASS EQ
LEVEL
MODE
CH2-CH4
L
R
L
R
L
R
CH1/2
CH3/4
GLX60.4 / GLX100.4 4-CHANNEL AMPLIFIER APPLICATIONS
4
Front/Rear high pass, using a 1 channel amplifier for mono sub bass
The combination of a 1 and a 4 channel amplifier, utilizing their built in
Channels 3/4:
crossovers, makes it a snap to put together a full system with front and rear
highs, with mono sub bass.
highs, with mono sub bass.
- HI PASS: 100 Hz
- LOW PASS: N/A
- LOW PASS: N/A
Interconnect cable checklist:
- Using good quality RCA cables, feed the front and rear outputs of a head unit to
- Using good quality RCA cables, feed the front and rear outputs of a head unit to
1 channel bass amplifier:
the inputs of the 4 channel amplifier as shown.
- Subsonic filter: 10 Hz to 40 Hz
- Also connect the LINE OUT of the 4 channel amplifier to the LINE INPUT of the
- LOW PASS: 80 Hz
1 channel amplifier as shown.
Please note that these frequency points are suggestions only. Refer to the
Mono bass woofer wiring:
loudspeaker manufacturer specifications and the section “Setting up systems
Connect the mono speaker positive terminal to the LEFT +, and its negative
after installation for best performance”
terminal to RIGHT -.
Level control checklist:
Switch setting checklist:
- Refer to the section “Setting up systems after installation for best performance”
4 channel highs amplifier:
- 1/2CH X-OVER: HI
- 1/2CH X-OVER: HI
Minimum final loudspeaker impedances:
- 3/4CH X-OVER: HI
4 Channel Amplifier:
Crossover frequency control checklist:
- 2 ohm per channel in stereo mode.
- 4 channel highs amplifier:
- 4 ohm mono bridged.
Channels 1/2:
1 Channel Amplifier:
- HI PASS: 100 Hz
- 1-Ohm to 4-Ohms
LOW PASS: N/A
STEREO
INTERCONNECT
RCA CABLE