Справочник Пользователя для Mitsubishi Electronics MR-J2M-P8A
4 - 16
4. OPERATION AND DISPLAY
4.3.5 Drive unit parameter mode
The parameter setting of the drive unit is the same as that of the interface unit. Refer to Section 4.2.5.
To use the expansion parameters, change the setting of DRU parameter No. 19 (parameter write disable).
Refer to section 5.1.1.
To use the expansion parameters, change the setting of DRU parameter No. 19 (parameter write disable).
Refer to section 5.1.1.
4.3.6 Drive unit external input signal display
The ON/OFF states of the digital input signals connected to the servo amplifier can be confirmed.
(1) Operation
Call the display screen shown after power-on.
Using the "MODE" button, show the diagnostic screen.
Using the "MODE" button, show the diagnostic screen.
@
External input signal display screen
(2) Display definition
Corresponds to the signals of the seven-segment LED.
TL1
PC
CR
RES
SON
LSN
LSP
CM2
CM1
CDP
Slot number
Always lit
Lit: ON
Extinguished: OFF
Extinguished: OFF
The 7-segment LED shown above indicates ON/OFF.
Each segment at top indicates the input signal and each segment at bottom indicates the output signal.
The following table indicates the signal names.
Each segment at top indicates the input signal and each segment at bottom indicates the output signal.
The following table indicates the signal names.
Signal Name List
Signal
Signal Name
Signal
Signal Name
LSP
Forward rotation stroke end
PC
Proportion control
LSN
Reverse rotation stroke end
TL1
Internal torque limit selection
SON
Servo-on
CM1
Electronic gear 1 selection
RES
Reset
CM2
Electronic gear 2 selection
CR
Clear
CDP
Gain switch selection