Справочник Пользователя для Mitsubishi Electronics MR-J2S- A
6 - 1
6. DISPLAY AND OPERATION
6. DISPLAY AND OPERATION
6.1 Display flowchart
Use the display (5-digit, 7-segment LED) on the front panel of the servo amplifier for status display,
parameter setting, etc. Set the parameters before operation, diagnose an alarm, confirm external
sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move to
the next screen.
To refer to or set the expansion parameters, make them valid with parameter No. 19 (parameter write
disable).
parameter setting, etc. Set the parameters before operation, diagnose an alarm, confirm external
sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move to
the next screen.
To refer to or set the expansion parameters, make them valid with parameter No. 19 (parameter write
disable).
Cumulative feedback
pulses [pulse]
pulses [pulse]
Motor speed
[r/min]
[r/min]
Droop pulses
[pulse]
[pulse]
Cumulative command
pulses [pulse]
pulses [pulse]
Command pulse
frequency [kpps]
frequency [kpps]
Speed command voltage
Speed limit voltage[mV]
Speed limit voltage[mV]
Torque limit voltage
Torque command voltage
Torque command voltage
Regenerative load
ratio [%]
ratio [%]
Effective load ratio
[%]
[%]
Peak load ratio
[%]
[%]
Within one-revolution
position low [pulse]
position low [pulse]
ABS counter
[rev]
[rev]
Load inertia moment
ratio [times]
ratio [times]
Sequence
External I/O
signal display
signal display
Output signal
forced output
forced output
Test operation
Jog feed
Jog feed
Test operation
Positioning operation
Positioning operation
Test operation
Motor-less operation
Motor-less operation
Software version L
Software version H
Automatic VC offset
Current alarm
Last alarm
Second alarm in past
Third alarm in past
Fourth alarm in past
Fifth alarm in past
Sixth alarm in past
Parameter error No.
Parameter No. 0
Parameter No. 1
Parameter No. 18
Parameter No. 19
Parameter No. 20
Parameter No. 21
Parameter No. 48
Parameter No. 49
(Note)
Note. The initial status display at power-on depends on the control mode.
Position control mode: Cumulative feedback pulses(C), Speed control mode: Motor speed(r),
Torque control mode: Torque command voltage(U)
Also, parameter No. 18 can be used to change the initial indication of the status display at power-on.
Torque control mode: Torque command voltage(U)
Also, parameter No. 18 can be used to change the initial indication of the status display at power-on.
MODE
button
DOWN
UP
Status display
Diagnosis
Basic
parameters
parameters
Expansion
parameters 1
parameters 1
Alarm
Expansion
parameters 2
parameters 2
Parameter No. 50
Parameter No. 51
Parameter No. 83
Parameter No. 84
Instantaneous torque
[%]
[%]
Within one-revolution
position, high [100 pulses]
Bus voltage [V]
Test operation
Machine analyzer operation
Motor series ID
Motor type ID
Encoder ID
[mV]