Справочник Пользователя для Power Acoustik PS1-4000D

Скачать
Страница из 16
3
WIRING CONNECTION
WARNING
A. CONNECTING THE POWER
    
(1) GROUND: To Vehicle Chassis
       To avoid unwanted ignition noise caused by ground loops, it is essential that the
       Amplifier be grounded to a clean, bare, metal surface of the vehicles chassis.
      
NOTE:
      GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT. (1 METER).
(2) +12 Volt (Fused) Constant Power: To Battery (+)
      Due to the power requirements of the Amplifier, this connection should be made
      directly to the positive (+) terminal of battery. For safety measure, install an in-line
      Fuse Holder (not included) as close to the battery positive (+) terminal as possible
      with an amperage rating: don't to exceed total value of fuses in Amp.
(3) Remote Turn-On Input: To Power Antenna output of Car Stereo
      This Amplifier is turned "ON" remotely when the vehicle's stereo is turned "ON".
      
NOTE:
       IF YOUR RADIO DOES NOT HAVE +12 VOLT OUTPUT LEAD WHEN THE
       RADIO IS TURNED  ON, THE "REM" TERMINAL ON THE AMPLIFIER CAN BE 
       CONNECTED TO VEHICLE'S ACCESSORY CIRCUIT THAT IS LIVE WHEN 
        THE KEY IS "ON".
Investigate the layout of your automobile thoroughly before drilling or cutting any
holes. Take care when you work near the gas tanks, lines, or hydraulic lines, and 
electrical wiring. Don't mount this system so that the wire connections ate 
unprotected or are subject to pinching or damage from nearby objects.
The +12 V DC power wire must be fused at the battery positive terminal connection.
Before making or breaking power connections at this system power terminals, 
disconnect the +12 V wire at the battery end.
Confirm your radio / cassette player and / or other equip is turned off while 
connecting the input jacks and speaker terminals.
If you need to replace the power fuse replace it only with a fuse identical to that
supplied with the system. Using a fuse of different type or rating may result in 
damage to this system which isn't covered by the warranty.
CAUTION:
AS A PRECAUTION, IT IS ADVISABLE TO DISCONNECT THE VEHICLE'S 
BATTERY BEFORE MAKING CONNECTION TO THE +12 VOLTS SUPPLY 
WIRING.
4 GAUGE (Thicker if planning for additional Amplifiers) wire is recommended both
the power and ground wires. 12 Gauge, for the remote turn-on wire. Both types are
available at most Mobile Audio Dealers or Installation Shops.