Справочник Пользователя для LOEWE 42

11 -

Install as manually rotatable table unit with the Table Stand included.
See accessories (page 58) for other installation options.

Press the embossed arrow and push down the 
battery compartment cover.
Insert two alkaline manganese LR 03 (AAA) batteries; 
ensure that the + and – poles are correctly positioned!
Slide the cover up from below.

Press the TV button.
See page 52 to find out how to operate other Loewe 
equipment.

Initial installation

Connect the TV set to a 220-240V power outlet:

First plug the small plug of the power cable into the 

power connection on the rear of the TV, then plug the 

large power plug into a mains power outlet. 

Analogue / DVB-C- / DVB-T antenna:

In sets with DR+: Plug the antenna plug of the antenna 

or cable system or the room antenna into the ANT2 

socket. The connecting cable between ANT-TV and ANT 

OUT has already been plugged in at the factory.

In sets without DR+: Plug the antenna plug of the 

antenna or cable system or the room antenna into the 

ANT-TV socket.

Satellite antenna, if upgraded:

Connect one antenna plug each, for example, from 

the antenna switch or the Twin-LNC of the satellite 

system to the ANT-SAT and ANT-SAT2 sockets (only for 

sets with DR+). If you only connect one SAT antenna 

cable, connect it to ANT-SAT.

Connections on the back of the set (see also page 5 and 6).

Connection and configuration of the network connection is 

described in the Network Mediaplayer operating manual.

When using a CA module and a Smart-Card to receive 

coded stations, please observe the handling of the CA 

module (see page 34).

TV

R

ANT

SAT

ANT2

ANT

SAT2

220-240V~

50/60Hz

ANT-TV

ANT

OUT