Справочник Пользователя для Panasonic C3333U

9

¡

Keep a battery away from children to avoid the risk of
accidents. If an infant ingests a battery, please seek
immediate medical attention.

¡

Remove and dispose of an old battery immediately.

¡

Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.

¡

Follow local regulations when disposing of a battery.

¡

Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.

Note:
¡

Battery Information:

Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)

The demonstration message appears for initial
use.
q Set your car’s ignition switch to the ACC or ON position. 

The demonstration screen appears.

w Press [SRC/PWR] to turn on the power.
e Press and hold [VOLUME] (PUSH SEL) for more

than 2 seconds to open the menu.

r Press [VOLUME] (PUSH SEL) to select the

Demonstration setting. (“DEMO” is displayed.)

t Turn [VOLUME] counterclockwise. (Press [0] (

{

) on

the remote control unit.)

Note:
¡

To return to the regular mode, press [D] (DISP).

¡

Refer to the section on “Function Settings”. 
(

a

Page 22)

The 12-hour system is used for the clock. 
q Press [SRC/PWR] to turn on the power.
w Press [D] (DISP/CLOCK).

Clock display

e Press and hold [D] (DISP/CLOCK) for more than 2

seconds.

Hour blinks

r Adjust the hour.
[[]: put forward hour.
[]]: put back hour.

Hour entered

t Press [D] (DISP/CLOCK).

Minute blinks

y Adjust the minute.
[[]: put forward minute.
[]]: put back minute.

Minute entered

u Press [D] (DISP/CLOCK).

Completed

Note:
¡

“ADJUST” is displayed before adjusting the clock.

¡

Press and hold [[] or []] to change numbers rapidly.

[SRC/PWR] (Power)

[]] [[]
(Hour/minute adjustment)

Pull the insulation film out from the
backside of the remote control gently.

q Remove the battery holder with the

remote control unit placed on a flat
surface.
q Stick your thumbnail into the

groove and push the holder in the
direction of the arrow at the same
time.

w Pull it out in the direction of the

arrow using a tough pointed object.

w Put a battery in the case with (+) side

facing up.

e Put the case back.

Tough pointed
object

Back side

[VOLUME] 
(PUSH SEL: select)