Справочник Пользователя для Panasonic CQ-C1110W
POWER
CLOCK
CQ-C1110W
D
IS
P
SQ
MUTE
7
8
9
10
11
12
SCAN
R
A
N
DO
M
1
2
3
4
6
APM
BA
N
D
SRC
5
VO
LUME / PUSH SEL
REP
TUNE
TRACK
D
•
M
DI
SP
MUTE
SRC
POWER
CLOCK
CQ-C1110W
D
IS
P
SQ
MUTE
7
8
9
10
11
12
SCAN
R
A
N
DO
M
1
2
3
4
6
APM
BA
N
D
SRC
5
VO
LUME / PUSH SEL
REP
TUNE
TRACK
D
•
M
D
IS
P
6
7
CQ-C1110W/C1100W
CQ-C1110W/C1100W
3
E
N
N
G
L
I
S
H
H
4
E
N
N
G
L
I
S
H
H
General
Mute
Press [MUTE] to mute the sound completely.
Press [MUTE] again or turn the knob clockwise
to cancel.
to cancel.
Volume
Turn [VOLUME] clockwise to increase
volume, and counterclockwise to
decrease volume.
volume, and counterclockwise to
decrease volume.
Volume level (0 to 40)
(default: 18)
Power
Turn the key in the ignition
until the accessory indica-
tor lights.
Power on: Press [SRC]
until the accessory indica-
tor lights.
Power on: Press [SRC]
(POWER).
Power off: Press [SRC]
(POWER) again
and hold.
and hold.
ACC
ON
MUTE
ST
Display change
Press [DISP] (display) to switch to the clock display.
Note: Please refer to next page when “AdJ” is displayed.
When the power is off:
No display
Clock display
Mute indicator
Up
Down
Remote control sensor (
➡
page 19)
(only for CQ-C1110W: CQ-C1100W has no remote control function.)
SQ indicator
SQ (Sound Quality)
SQ is a function that can call up various sound types at the
touch of button in accordance with your listening music
type.
Press [SQ] to select a sound type as follows:
touch of button in accordance with your listening music
type.
Press [SQ] to select a sound type as follows:
SQ -- (default)
flat frequency response:
does not emphasize.
does not emphasize.
SQ - 1 (ROCK)
speedy and heavy sound:
exaggerates bass and treble.
exaggerates bass and treble.
SQ - 2 (POP)
wide-ranged and deep sound:
slightly emphasizes bass and treble.
slightly emphasizes bass and treble.
SQ - 3 (VOCAL)
clear sound:
emphasizes middle tone and
slightly emphasizes treble.
emphasizes middle tone and
slightly emphasizes treble.
Clock setting
Note: If no operation takes place for more than 5 seconds
in audio mode (2 seconds in volume mode), the display
returns to the regular mode.
in audio mode (2 seconds in volume mode), the display
returns to the regular mode.
Audio mode
(Bass/Treble/Balance/Fader)
(Bass/Treble/Balance/Fader)
Volume
Bass
Treble
Balance
Fader
Regular mode
Push [SEL] to select the audio mode.
Turn [VOLUME] clockwise to increase volume,
and counterclockwise to decrease volume.
and counterclockwise to decrease volume.
Note: If the fader is set to front, the pre-amp.
output (rear) is decreased.
output (rear) is decreased.
[DISP] (CLOCK)
The 24-hour system is used for the clock.
[k TUNE], [l TUNE] (Hours, minutes)
Hours
w Press and hold [DISP] (CLOCK) for more than
w Press and hold [DISP] (CLOCK) for more than
2 seconds.
Initial time
q Press [DISP] (CLOCK).
(Hours blink.)
e Press [k TUNE] or [l TUNE].
(Hours set.)
Minutes
r Press [DISP] (CLOCK).
r Press [DISP] (CLOCK).
(Minutes blink.)
t Press [k TUNE] or [l TUNE].
(Minutes set.)
y Press [DISP] (CLOCK).
Note: Press and hold [k TUNE] or [l TUNE] to
change numbers rapidly.
change numbers rapidly.
Time reset
Press and hold [DISP] (CLOCK) for more than
2 seconds to activate the time setting mode to
reset the time.
Then, repeat steps e to y.
2 seconds to activate the time setting mode to
reset the time.
Then, repeat steps e to y.
(End.)
push
q
w
“AdJ” is displayed when the clock is not adjusted.
Bass:
Adjustable range: –12 dB to +12 dB (by 2 dB step)
Treble:
Adjustable range: –12 dB to +12 dB (by 2 dB step)
Balance:
Adjustable range: 1 to 15 (by 1 step)
Balance center
R (right speaker) or L (left speaker)
Fader:
Adjustable range: 1 to 15 (by 1 step)
Fader center
F (front speaker) or R (rear speaker)
(default: 0 dB)
(default: 0 dB)
(default)
(default)
(default)
Notes:
• If no operation takes place for more than 2 seconds in the SQ mode, the display returns to the regular mode.
•
• If no operation takes place for more than 2 seconds in the SQ mode, the display returns to the regular mode.
•
Settings of SQ, bass/treble are influenced one another. If the influence mentioned above causes distortion to audio
signal, readjust bass/treble or volume (
➡
page 7)
.