Руководство По Работе для ONKYO TX-SR702

 

92

 

• Relocate your antenna.
• Move the AV receiver away from your TV or com-

puter.

• Listen to the station in mono (page 56).
• When listening to an AM station, operating the remote 

controller may cause noise.

• Passing cars and airplanes can cause interference.
• Concrete walls weaken radio signals.
• If nothing improves the reception, install an outdoor 

antenna.

 

• Make sure that the batteries are installed with the cor-

rect polarity (page 13).

• Install new batteries. Don’t mix different types of bat-

teries, or old and new batteries (page 13).

• Make sure that the remote controller is not too far 

away from the AV receiver, and that there’s no 
obstruction between the remote controller and the AV 
receiver’s remote control sensor (page 13).

• Make sure that the AV receiver is not subjected to 

direct sunshine or inverter-type fluorescent lights. 
Relocate if necessary.

• If the AV receiver is installed in a rack or cabinet with 

colored-glass doors, the remote controller may not 
work reliably when the doors are closed.

• Make sure you’ve selected the correct remote control-

ler mode (page 13).

• When using the remote controller to control other 

manufacturers’ AV components, some buttons may 
not work as expected.

• Make sure you’ve entered the correct remote control 

code.

 

• If it’s an Onkyo component, make sure that the 

 

cable and analog audio cable are connected properly. 
Connecting only an 

 cable won’t work (page 37).

• Make sure you’ve selected the correct remote control-

ler mode (page 14).

• If you connect an MD recorder or CD recorder to the 

TAPE jacks, be sure to set make the necessary setting 
(pages 52 and 80).

• When learning commands, make sure that the trans-

mitting ends of both remote controllers are pointing at 
each other.

• Are you trying to learn from a remote controller that 

cannot be used for learning? Some commands cannot 
be learnt, especially those that transmit several 
instructions with a single button press.

• The wrong remote control code has been entered.
• The entered remote control code may not be correct. If 

more than one code is listed, try each one.

• With some AV components, certain buttons may not 

work as expected, and some may not work at all.

• To control Onkyo components, point the remote con-

troller at the AV receiver.

• To control another manufacturer’s component, point 

the remote controller at that component.

 

• On your recorder, make sure the correct input is 

selected (e.g., digital or analog).

 

• Was the Sleep function set? The Sleep function turns 

off Zone 2 as well as the AV receiver. To set the Sleep 
function for Zone 2 only, see page 78.

 

• Since the Zone 2 function and the REC OUT outputs 

use the same circuitry, you cannot use Zone 2 and 
record at the same time. When the [REC OUT] button 
is pressed, Zone 2 is turned off.

• Only components connected to analog inputs can be 

played in Zone 2.

TX-NR702,602_En.book Page 92 Tuesday, September 7, 2004 1:18 PM