Справочник Пользователя для Pelco IS310-DW

C3429M-A (1/08)

17

The IS310 Series Camclosure integrated camera system includes a service connector that outputs camera 
video. Use it at the installation site to set up the field of view and focus the camera.

Figure 13.  Service Connector

Pelco offers two optional items that plug directly into the service connector: CST150 compact field tool 
and IS-SC cable.

•

The optional CST150 compact field tool has a 3-foot (0.9 m) cable and microdisplay for viewing 
camera video. Plug it into the service connector to view the video.

NOTE: The three buttons on the CST150 are not used with the IS310 Series Camclosure.

•

The optional IS-SC is a 4-foot (1.2 m) cable with a service connector and a BNC connector. Plug the 
cable into the service connector on the IS310. Then connect the other end to any standard BNC 
(VIDEO IN) connector on a monitor.

To assemble a longer service cable for the Camclosure integrated camera system, purchase the following 
items from a local electronics supply store:

1

2.5 mm monaural headphone plug

1

CPM 88 miniature coaxial connector

1

RG174/U coaxial cable

To assemble the cable:

1. Attach the CPM 88 miniature coaxial connector to one end of the cable. Follow the directions 

supplied with the miniature coaxial connector.

2. Attach the 2.5 mm monaural plug to the other end of the coaxial cable (refer to Figure 14):

a.

Remove the support sleeve from the plug. Slip the support sleeve over the end of the cable. 

b.

Prepare the cable. Solder the center connector of the cable to the center pin of the plug. 
Thread the braid of the cable through the hole in the crimp pin.

c.

Solder the braid to the top of the crimp pin. Crimp the end of the crimp pin around the cable. 
Reassemble the support sleeve and the plug.

Figure 14.  Attaching the 2.5 mm Monaural Headphone Plug

SERVICE 
CONNECTOR

2.5 MM MONAURAL 
HEADPHONE PLUG

CENTER CONDUCTOR

BRAID (SHIELD)

COAXIAL
CABLE