Справочник Пользователя для Pelco IP110
C3432M-G (4/09)
35
Troubleshooting
If the following instructions fail to solve your problem, contact Pelco Product Support at 1-800-289-9100
(USA and Canada) or +1-559-292-1981 (international) for assistance. You should have the serial number
from the product label available.
(USA and Canada) or +1-559-292-1981 (international) for assistance. You should have the serial number
from the product label available.
Do not try to repair the unit yourself. Opening it immediately voids any warranty. Leave maintenance and
repairs to qualified technical personnel. Exchange the defective unit and return it for repair.
repairs to qualified technical personnel. Exchange the defective unit and return it for repair.
Table F. Troubleshooting the IP110 Series (1 of 3)
Problem
Possible Cause
Suggested Remedy
No video
PoE power issue
• Check Cat5 cable connection.
• Verify PoE is enabled.
• Disconnect the Cat5 cable from the PoE, and then
• Verify PoE is enabled.
• Disconnect the Cat5 cable from the PoE, and then
reconnect the cable. Check the LED inside the back
box to verify that it is flashing green, indicating the
camera has power.
box to verify that it is flashing green, indicating the
camera has power.
Power issue (24 VAC)
• Check the 24 VAC power supply connection.
• Disconnect the network cable, and then reconnect it
• Disconnect the network cable, and then reconnect it
to the camera. Check the LED inside the back box to
verify that it is flashing green, indicating the camera
has power.
verify that it is flashing green, indicating the camera
has power.
Network connectivity
issues
issues
• Check network cable connections.
• Disconnect the network cable, and then reconnect it
• Disconnect the network cable, and then reconnect it
to the camera. Check the LED inside the back box to
verify that it is flashing green.
verify that it is flashing green.
• Replace network cable with new cable.
Defective camera
• Check the camera’s 10-pin connector inside the back
box to make sure it is connected.
• Use a service connector to check camera operation.
Connect one end of the service connector to the
service connector input inside the back box. Then
connect the other end of the service connector to a
monitor.
service connector input inside the back box. Then
connect the other end of the service connector to a
monitor.
• Replace camera module with new camera.
Image too dark/
black image
black image
Installation error
• Make sure the lens cover in not installed.
• Make sure camera is not located in an environment
• Make sure camera is not located in an environment
with zero light.
• Use a service connector to check camera operation.
Connect one end of the service connector to the
service connector input inside the back box. Then
connect the other end of the service connector to a
monitor.
service connector input inside the back box. Then
connect the other end of the service connector to a
monitor.
• Replace camera module with new camera.