Справочник Пользователя для Pelco ED2500

PELCO Manual C437M-B (9/95)

3

CAUTION: Make certain that the mounting
surface is capable of supporting the full load of
the mount, pan/tilt, camera/lens and enclosure

•

Handle the lower dome with care so as not to
scratch or get fingerprints on the viewing window.

•

When installing the unit, loosen the two (2) fas-
teners and remove the pan/tilt or camera mount to
reduce the total weight of the enclosure.

•

When the pan/tilt or camera mount is removed,
install the camera/lens and make sure the electri-
cal connections to the pan/tilt (camera power, lens
power and video) are made.

•

When closing the enclosure, be sure the drive tab
on the dome engages the slot on the drive arm of
the pan/tilt.

WARNING: Do not rotate pan/tilt by hand.
Rotate by controller only.

The ED25/ED2520/ED2620 Series of environmental
domes can be installed by using one of the following
mounts:

•

FMED25

Flush mount adapter. Adapts dome
to ceiling. Required for all flush
mount applications.

•

PAED25

Discontinued. (Use PA102 with
ED27 Series dome.)

•

PMED25

Pendant mount adapter.

•

UMED25

Discontinued.

•

WMED25

Discontinued. (Use ED27 Series
dome with integral mount.)

Mount the enclosure according the following directions
for the selected mount.

To mount the enclosure using the FMED25 flush mount,
perform the following steps. Refer to Figure 2.

1.

Secure the FMED25 flush mounting plate to a suit-
able surface and secure with suitable fasteners (not
supplied) capable of supporting the weight of the
dome, pan/tilt, camera and lens. Due to the wide
range of installations this mount could be used in,
drilling of holes in the mounting plate will be re-
quired.

2.

Install the provided gasket over the four (4) studs
on the FMED25 mounting plate.

3.

Align the four (4) studs in the FMED25 with the
four (4) holes in the top of the dome. Then, secure
the dome to the mounting plate by using the four
(4) 1/4-20 nuts supplied with the mount.

Figure 2. FMED25 Installation