Справочник Пользователя для Pelco CCC1300H-2X
4
Pelco Manual C1961M-B (3/01)
DESCRIPTION
The CCC1300H-2, CCC1300H-2X, and MCC1300H-2 Digital Cameras are high
resolution, compact video cameras that feature a 1/3-inch CCD imager. The camera’s
high resolution and high-density image sensor ensure a sharp and clear picture over a
wide range of conditions.
resolution, compact video cameras that feature a 1/3-inch CCD imager. The camera’s
high resolution and high-density image sensor ensure a sharp and clear picture over a
wide range of conditions.
MODELS
CCC1300H-2
1/3-inch, high resolution color CCD camera, 24VAC, 60Hz, NTSC
CCC1300H-2X
1/3-inch, high resolution color CCD camera, 24VAC, 50Hz, PAL
MCC1300H-2
1/3-inch, high resolution monochrome CCD camera, 24VAC, 60Hz, EIA
LOCATION AND FUNCTION OF PARTS
Refer to Figure 1.
1
Lens Mount
The camera has a standard CS lens mount, but can use a C-mount lens when a
C/CS-mount adapter is installed between the lens and camera.
C/CS-mount adapter is installed between the lens and camera.
2
Back Focus Lock Screw
Loosen to adjust the back focus to match the lens attached to the CS mount.
Refer to the section on
Refer to the section on
Back Focus Adjustment in this manual.
3
Camera Mounts
Top or bottom mounting. Maximum thread length is 3/16-inch. Attach the camera
mount adaptor to extend thread depth to a standard 1/4-inch.
mount adaptor to extend thread depth to a standard 1/4-inch.
4
Level Adjuster
Controls the video output level when using a DC-controlled auto iris lens.
5
Lens Connector
Four-pin auto iris drive connector.
6
Video Output Connector
This coaxial connector (BNC-type) outputs the video signals.
7
Iris Mode Selector Switch
Switch to VIDEO when an auto iris lens is controlled by a video signal. Switch to
DC when using a DC voltage drive lens.
DC when using a DC voltage drive lens.
8
LL ADJ Switches
Use switches to adjust the vertical phase up or down to eliminate vertical roll
when multiple cameras are connected to a switching device. Each camera’s
output is synchronized to the frequency of the power supply.
when multiple cameras are connected to a switching device. Each camera’s
output is synchronized to the frequency of the power supply.
9
AGC - Automatic Gain Control
Automatically adjusts the image to compensate for changes in light levels.
The AGC function switch can be turned ON/OFF by moving the AGC switch right
or left. AGC is factory set to ON.
The AGC function switch can be turned ON/OFF by moving the AGC switch right
or left. AGC is factory set to ON.