Справочник Пользователя для Pelco CCC1370H-2X

12

C1961M-E (8/03)

The eclipser function is available only on NTSC and EIA models. It is set at the factory and usually
does not need to be readjusted. However, if fine tuning is necessary, do the following:

1. Set the DIP switches.

a. AGC: OFF
b. ESC: OFF
c. BLC: OFF

2. Set the IRIS MODE selector.

a. Auto iris lens controlled by video signal - VIDEO
b. Auto iris lens controlled by DC voltage - DC

3. Set the variable resistors and Eclipse DIP switch.

a. THRE:

Counterclockwise

b. ECLP:

Mechanical center

c. GRAY:

Mechanical center

d. ECLIPSER DIP: OFF

4. Set the response selector of the auto iris lens (video type) to AVERAGE. While viewing an

object, set the video output level of the camera to 0.75 Vp-p (100 IRE) by adjusting the LEVEL
VR of the auto iris lens.

5. While viewing a brightly lit object (Refer to Figure 2):

a. Set ECLIPSER DIP switch to ON.

b. Adjust THRESHOLD variable resistor by turning it clockwise. Set the video output level to

clip at 0.8~0.85 Vp-p.

c. Set gray level to 0.35 Vp-p by turning the GRAY variable resistor clockwise or

counterclockwise.

6. While viewing an object in front of a bright background (refer to Figure 3), adjust the ECLP

variable resistor by turning it clockwise or counterclockwise until the foreground is clear (sharp)
and the background appears gray.

GRAY

BACKGROUND

Figure 2.  Gray Level Setting

Figure 3.  Image on Monitor

GRAY LEVEL

0.35 VP-P

0.8~0.85 Vp-p

v