Справочник Пользователя для Pelco C626M-B
C626M-B (3/05)
53
DX8000 PC Client Application
PTZ PATTERNS
A pattern is a user-defined, viewable camera path with a definite beginning and end. Patterns are made up of a sequence of standard pan, tilt,
and lens commands. Patterns are stored in the internal memory of the PTZ device, such as a Spectra dome, that is connected to the DX8000.
Depending on the type and configuration of the PTZ device, the DX8000 can address up to four unique PTZ patterns. Once defined, a pattern can
be activated with a series of on-screen commands. A pattern will run continuously until it is deactivated.
and lens commands. Patterns are stored in the internal memory of the PTZ device, such as a Spectra dome, that is connected to the DX8000.
Depending on the type and configuration of the PTZ device, the DX8000 can address up to four unique PTZ patterns. Once defined, a pattern can
be activated with a series of on-screen commands. A pattern will run continuously until it is deactivated.
PROGRAMMING A PATTERN
To program a pattern:
1. Click .
2. Drag a camera from the site tree onto a view panel.
3. Click
to enter programming mode.
4. Using the PTZ keypad, select a number for the pattern (1 to 4).
5. Click .
6. Move the camera through a series of movements using the on-screen pan and tilt, zoom, and focus controls.
Figure 59. Programming a Pattern
To stop programming a pattern:
1. Click .
2. Click .
NOTE: Only PTZ-enabled cameras that support pattern programming through D, P, or Coaxitron protocols can use this feature.
NOTE: Certain PTZ devices, like Pelco’s Spectra series domes, will display an on-screen message stating the amount of remaining memory
available for pattern programming.
available for pattern programming.