Справочник Пользователя для Pelco C707M-B

2

Pelco Manual C707M-B (11/96)

The  information contained within this manual covers
the installation and operation of Pelco TVJ6AC-1 and
TVJ6MS-1 motorized zoom lenses.

Installation should be in accordance with all applicable
local and national electric codes, utilizing approved
materials only.

Please thoroughly familiarize yourself with the infor-
mation in this manual prior to installation and opera-
tion.

Pelco’s TVJ6AC-1 and TVJ6MS-1 are 2/3" format
motorized zoom lenses designed to provide remote
control of zoom, focus and iris functions on the
TVJ6MS-1 lens, and zoom and focus only on the
TVJ6AC-1 lens.  These lenses feature color corrected
professional quality optics.

The TVJ6MS-1 is equipped with a tapered neutral den-
sity spot filter as an integral part of the lens to permit
light attenuation beyond the normal range of a zoom
lens down to f360. The spot filter is densest toward the
center and decreases toward the circumference, permit-
ting operation of low-light level cameras in brightest
daylight down to minimum required faceplate illumi-
nation.

The TVJ6AC-1 is equipped with a tapered neutral den-
sity spot filter and internal automatic iris electronics
for fully automatic iris operation on low-light level
CCTV cameras.

Models with the letters “LPP” in the part number are
equipped with potentiometers for the zoom and focus
drive motors, providing a means for preset positioning
commands from a microprocessor based control unit
to automatically drive zoom and focus functions.

The following distances are for reference only and are
the approximate maximum recommended under the fol-
lowing conditions:

— 30mA maximum at 12 VDC
— Single lens function activation
— Single common conductor in lens cable
— 10% loss in voltage

22 Awg to 1,236 feet (377 m)
20 Awg to 1,968 feet (600 m)
18 Awg to 3,133 feet (955 m)
16 Awg to 4,974 feet (1,516 m)

NOTE:  Video limited to 500 feet on RG-59
coax  cable without equalization amplifier.

This lens features a spot filter and internal auto-iris
circuitry for use with low-light level CCTV cameras.

The auto-iris circuitry must sample either composite or
non-composite video from the camera and be supplied
with 9 to 18 VDC. Functions are on a separate cable.

Wiring is as follows:

Connector

Function

Color

Pin Number

Zoom

Green

2

Focus

White

3

Common

Black & Red

4

           Small
4-Conductor Cable*

Auto Iris Cable

Red wire

VCC (+9 to +18 VDC)

Black wire

Ground

White wire

Video Signal

Green wire

VCC (+9 to +18 VDC)

*Plug for this cable is provided with the camera.