Справочник Пользователя для Pelco AD2088

10

C2688M-C (12/08)

In addition to the standard tools and cables required for a video security installation, you need to provide the following items:

The product serial number label helps identify your data interface and its factory configuration settings in the event that the unit requires service.

A label citing your product’s serial number is attached to the bottom panel of the data interface. Because rack mounting or other installation 
options may obscure the factory-applied label, two additional labels are provided. Attach one label to your product documentation or another 
product location that will not be obscured by installation. The second label is a spare.

To use the serial number label, complete the following steps:

1. On the bottom panel of the data interface, locate the two small labels, attached with a yellow sticker that reads “Extra serial number 

labels: remove prior to installation.”

2. Remove the yellow sticker and the labels.

3. Peel away the backing from one label and attach it to this manual, other product documentation, or an unobscured product location.

Figure 4. Product Serial Number Label

Use one of the following installation methods for the data interface (detailed instructions are provided in the following sections):

•

Desktop installation: Turn the unit upside down. Remove the backing from the rubber feet (supplied) to expose the glue, and attach the 
feet to the corners of the unit. Turn the unit right side up. Place the data interface on a flat surface, such as a shelf or desktop. This 
installation method requires the installation of a separate power supply.

•

Wall mount installation: Mount the data interface to a wall using the optional WM5001-4U wall mount kit. This installation method 
requires the installation of a separate power supply.

•

Rack mount installation: Install the data interface in the optional RK5100PS-5U rack mount kit; the RK5100PS-5U supplies power to the 
EDI5000 unit.

To place the data interface on a flat surface, such as a desktop, complete the following steps:

1. Make sure the rubber feet are installed on the unit to prevent surface damage.

2. Position the unit to allow for cable and power cord clearance at the front and rear panels.

1  Cat5e (or better) cable with the individual wires exposed at each end (for connecting the data interface to the matrix keyboard 

wallblock connector)

1  Power supply; refer to Power Connection on page 16 for more information

MODEL

FREQ

Sample Text

Sample Text

AMPS

VOLTS

Sample Text

REV

Sample Text

03267-39-0020

SN