Справочник Пользователя для VIVOTEK PZ7152

This section explains how to confi gure the Network Camera to Internet connection. 

1. If you have external devices such as sensors and alarms, make connection from general I/O 

    terminal block.
2. Connect the camera to a switch via Ethernet cable.
3. Connect the supplied power cable from the Network Camera to a power outlet.

There are several ways to setup the Network Camera over the Internet. The fi rst way is to setup 
the Network Camera behind a router. The second way is to utilize a static IP. The third way is to 
use PPPoE.

Before setting up the Network Camera over the Internet, make sure you have a router and follow 
the steps below.

1. Connect your Network Camera behind a router, the Internet environment is illustrated as 
    below. About how to get your IP address, please refer to Software installation on page 12 for 
    details.

IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1

IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1

LAN (Local Area Network)
Router IP address : 192.168.0.1

WAN (Wide Area Network )
Router IP address : from ISP

Cable or DSL Modem

LAN (Local Area Ne
Router IP address :

WAN (Wide Area Network )
Router IP address : from ISPP

POWER

COLLISION

LINK

RECEIVE

PARTITION

1

2

3

4

5

Ethernet switch

POWER

COLLISION

LINK

RECEIVE

PARTITION

1

2

3

4

5

1: Power
2: Digital ouput
3: Digital input
4: Ground