Справочник Пользователя для RCA DRC62708
8
9
Placement
Mounting in the Vehicle
Use the supplied mounting straps to install the units on the back of the vehicle's headrests. Tightly wrap the
mounting strap around the headrest.
mounting strap around the headrest.
SAFETY WARNING!
• This unit should never be used by the vehicle's driver or left unsecured in the vehicle while driving.
• If this unit is being used in your vehicle, be sure that it is secured or held safely, and does not obstruct any
• This unit should never be used by the vehicle's driver or left unsecured in the vehicle while driving.
• If this unit is being used in your vehicle, be sure that it is secured or held safely, and does not obstruct any
safety device, including air bags or seat belts.
• All passengers should wear seat belts when using this unit in a moving vehicle.
• If in doubt, please contact your vehicle manufacturer for further advice.
• If in doubt, please contact your vehicle manufacturer for further advice.
DVD Player A
Mounting
Straps
AV cable
Car power
adapter splitter
Remote Control A
Remote Control B
DVD Player B
Using Headphones/Earphones
Turn down the volume before connecting the headphones/earphones. Slowly raise the volume with the
headphones on until you reach your desired volume. When headphones are connected, the speaker is
automatically disabled.
headphones on until you reach your desired volume. When headphones are connected, the speaker is
automatically disabled.
Warning:
Excessive sound pressure from earphones and
headphones can cause hearing loss. Avoid
listening to sound at excessive levels which
could be harmful to your ears.
Excessive sound pressure from earphones and
headphones can cause hearing loss. Avoid
listening to sound at excessive levels which
could be harmful to your ears.
Connecting to a Stereo Receiver or Amplifier
The unit can recognize Dolby Digital content from a DVD and provide a down-mix suitable for stereo
playback.
playback.
Listening on External Audio Equipment
1. Connect the DVD Players to the left/right Audio In jacks on the audio equipment using an Audio/Video
1. Connect the DVD Players to the left/right Audio In jacks on the audio equipment using an Audio/Video
cable.
2. Turn on the DVD Players. Slide the DVD/AV IN switch on DVD Player A to "DVD".
3. Turn on the audio equipment and follow the instructions provided with it to select the AUDIO IN
3. Turn on the audio equipment and follow the instructions provided with it to select the AUDIO IN
function.
Note:
• Make sure to use the correct Audio cable. Connecting the plugs incorrectly may cause a weak signal.
• If you have a stereo VCR, make sure you set it to stereo mode.
• Due to copyright protection, DVD movies cannot be copied. If you copy a DVD movie onto a videotape, the
• Make sure to use the correct Audio cable. Connecting the plugs incorrectly may cause a weak signal.
• If you have a stereo VCR, make sure you set it to stereo mode.
• Due to copyright protection, DVD movies cannot be copied. If you copy a DVD movie onto a videotape, the
resulting copy will be unclear, with poor sound quality. This is NOT caused by a defective DVD system.
DVD Player A
Stereo Receiver
or Amplifier
No need to connect
the yellow video plug
DVD Player B
Stereo Receiver
or Amplifier
No need to connect
the yellow video plug
Earphones
(1/8” [3.5mm] diameter plug)
DVD Player A
DVD Player B