Справочник Пользователя для Panasonic CY-VHD9500U

84

85

Note:
≥ In some cases, the picture looks different from 

the original one due to your selection of aspect.

≥ This is to remind you that compression or 

extension of the screen using the aspect ratio 
changing function of this product for commercial 
purpose of profi t making or viewing/listening 
by the public could infringe on the rights of the 
author protected by the copyright law.

≥ If you expand normal picture (4 to 3) by using 

“JUST”, “ZOOM” or “FULL” aspect to the full of 
the screen, you might not see the periphery of 
the picture, or you might see a distorted picture. 
Therefore, use the “NORMAL” mode to see the 
original pictures as the author intended it.

Press [A] (ASPECT) to change the aspect ratio as 
follows.
Default: NORMAL
Mode: 4 types

NORMAL
≥ The conventional display 

image has a 4 to 3 ratio 
of horizontal to vertical.

≥ In this case, a blank area 

remains on the right and 
left sides of the display.

FULL
≥ The screen is extended 

horizontally as a whole 
to the aspect of 16 to 9.

≥ The extension ratio is 

the same at any point of 
the screen.

ZOOM
≥ The screen is fully 

extended at the normal 
aspect ratio of 4 to 3.

≥ The top and bottom of 

the screen are slightly 
cut.

JUST
≥ The screen is extended 

horizontally to the aspect 
ratio of 16 to 9.

≥ The extension ratio 

increases toward the 
right and left ends of the 
screen.

Note:
≥ Be careful not to scratch the surface of the front 

cover when attaching it.

A

A

A

1

 

2

3

5

6

Preparation:
≥ Turn the dome light switch off (page 46).
≥ Open the display unit (page 50).

1

 Remove the 2 screws.

2

   Place your fi ngers at A (in 2 places) on the 

panel, and slowly pull down the panel.

3

 Pull out the bulb to be replaced.

 

≥  Do not turn the bulb but pull it straight out.

4

 Push the new bulb into place.

5

  Insert the end of the panel, and push it back into 

place as shown in the fi gure.

6

 Secure the screws.

Caution:
≥ Ask a qualifi ed specialist to do this job.
≥ While you are replacing a bulb, be absolutely 

≥ The bulb is very hot to the touch while it is 

≥ Use a bulb with the specifi ed ratings 

≥ Gripping the bulb with too much force may