Справочник Пользователя для John Deere RC1048

ATTACHING

• Detaching Cutter from Tractor

CAUTION: To prevent personal injury caused
by unexpected movement:

a. Park machine on a level surface.
b. Engage tractor parking brake and/or

place transmission in “Park”.

c. Disengage PTO.
d. Shut off tractor engine and remove key.

1. Park cutter on a level surface, or block tail-

wheel so machine cannot roll after detaching
from the tractor.

2. Slowly push hitch control lever to lower cutter

close to the ground.

3. Engage tractor parking brake and/or place

transmission in “Park”.

Shut off tractor engine before

detaching PTO driveline. Entanglement in
rotating driveline can cause serious injury
or death.

4. Shut off tractor engine and remove key.
5. Raise tractor PTO shield, if equipped.

IMPORTANT: Do not use plastic shield on driveline to
hold driveline in position. Damage to shielding can occur.

6. Pull collar back toward cutter and slide drive

line off tractor shaft.

7. Support and collapse driveline completely and

lower onto PTO holder.

8. Lower tractor PTO shield, if equipped.

4. Shorten center link or lengthen lift links to

provide clearance. (See your tractor
Operator’s Manual.)

IMPORTANT: PTO driveline may be too long for some
tractor models, causing tractor transaxle damage. Hold
driveline sections parallel to each other and check for a
minimum of 6 inches overlap.

5. Raise and lower cutter slowly to check for

binding or interference. Check cutter-to-tractor
driveline telescoping length to ensure it does
not bottom out. Modify driveline if necessary.
(See MODIFING PTO DRIVELINE
in Assembly section.)

16 Detaching

(continued on next page)

(continued from previous page)

DETACHING

Shut off tractor engine before

DANGER