Справочник Пользователя для Dolmar MS-230 C

1

F

-  You can adjust the line to the right length at any time by lightly 

tapping the trimmer head against the ground (direction of 

arrow). The line cutter automatically cuts off excess line.

  However, this only works when at least 3 cm of line are vis-

ible at each end.

-  If the line ends are shorter than 3 cm, it will be necessary 

to adjust the trimmer line manually.

-  To do this, push the button firmly and pull out the line ends

forcefully.

cap before replacing the line!
-  Push the housing tabs (f/1) inward to remove the housing 

cover (f/2).

-  Remove the spool (f/5) from the housing cover (f/2) remove 

all line and line fragments.

-  Cut line (diam. .4 mm) to 7.5 m length.

-  Engage the nylon line in the cutout (f/6) so that one end of 

the line is about 80 mm longer than the other. Then wind both 

ends tightly about the spool in the direction of the arrow.

-  After winding the line, temporarily insert the ends in the cutouts 

(f/4). Leave about 100 mm protruding on each end.

-  Place the spool (f/5) in the housing cover (f/2). Remove 

the line ends from the cutouts (f/4) and pull them through 

the metal eyelets (f/3) in the housing cover.

-  Line the housing tabs (f/1) up with the housing cover (f/2) 

and push together firmly until both tabs click into position

audibly.

(MS-30 C / MS-60 C / MS-330 C)

and wear protective gloves!
-  Unscrew the screws (g/5) and remove the old line knife.
-  Mount the new line knife (g/4) as shown (towards the trim-

mer head) with screws (g/5).

noTE:  Do  not  overtighten  the  screws. The  protective  hood 

is made of plastic, and overtightening can strip the threads. If 

this has happened and it is not possible to mount the line knife 

firmly, the protective hood must be replaced.

E

G