Справочник Пользователя для Land Pride RCR1248
11
Section 1: Assembly & Set-up
12/15/15
RCR1248, RCR1260 and RCR1272 Rotary Cutter 326-047M
Driveline Installation (Shear Bolt Driveline Shown)
Figure 1-5
30240
30291
Refer to Figure 1-5:
1.
Unsnap side access covers (#4) from both sides of
the gearbox shield. Save covers for reuse.
the gearbox shield. Save covers for reuse.
2.
Remove bolt (#2) from end of driveline (#5).
3.
Slide driveline (#5) onto gearbox input shaft until
holes in driveline yoke aligns with hole in gearbox
input shaft.
holes in driveline yoke aligns with hole in gearbox
input shaft.
4.
Insert bolt (#2) through driveline yoke and gearbox
input shaft.
input shaft.
5.
Secure bolt with removed nut (#3). Tighten hex nut to
the correct torque.
the correct torque.
6.
Skip to step #8 is installing a slip clutch driveline.
7.
If driveline (#5) has a shear bolt instead of a slip
clutch, install snap ring (#1) onto the gearbox input
shaft groove. Discard snap ring if driveline has a slip
clutch.
clutch, install snap ring (#1) onto the gearbox input
shaft groove. Discard snap ring if driveline has a slip
clutch.
8.
Reinstall access covers (#4).
9.
Raise driveline (#5) up and rotate driveline hook (#6)
down.
down.
10. Lower driveline (#5) until resting in driveline
hook (#6).
11. Continue with “3-Point Hook-Up” on page 12.
NOTE: Snap ring (#1) is for extra security should
driveline shear bolt (#2) break. Do not use snap ring
with a slip clutch driveline.
driveline shear bolt (#2) break. Do not use snap ring
with a slip clutch driveline.