Справочник Пользователя для Land Pride rcfm3610

26

12/15/15

Refer to Figure 1-24 on page 27:
1.

Make sure you have read and follow all Safety Alerts 
and Important Notes listed above continuing.

2.

Adjust drawbar length so that center of drawbar hitch 
pin hole and end of tractor PTO shaft is set at the 
correct distance. See “Pull-Type Hitch” on page 10 
for distance.

3.

Make certain parking jack (#10) is properly attached 
to cutter hitch and secured with detent pin (#11).

4.

Back tractor within close proximity of clevis (#2).

5.

Raise or lower parking jack (#10) to align clevis (#2) 
with tractor drawbar. Drawbar should fit between 
lower and upper plates of clevis.

IMPORTANT: Proper distances between center of 
drawbar hitch pin hole to end of tractor PTO shaft 
and from top of drawbar hitch to center of PTO shaft 
must be maintained for Pull-Type hitches.

IMPORTANT: Jack attachment pin must be fully 
inserted and secured before working on or around a 
cutter not hooked to the tractor drawbar.

6.

Back tractor up to cutter hitch until holes in drawbar 
and clevis (#2) are aligned.

7.

Install 1" flat washers (#5) above and below drawbar.

8.

Insert 1" -8 x 4 1/2" hex bolt (#3) through top of 
clevis (#2), 1" flat washer (#5), tractor drawbar, 
second 1" flat washer (#5) and out through bottom of 
clevis hitch (#2). Secure bolt with hex locknut (#4). 
Tighten lock nut snugly to remove all play and then 
back nut up one-quarter turn.

9.

Lower parking jack (#10) until hitch weight is 
supported by tractor drawbar. 

10. Fully retract parking jack (#10), remove locking 

pin (#11), and store parking jack on cutter deck with 
locking pin in area shown.

11. Pull back on driveline yoke collar (#9) and push 

driveline yoke onto tractor PTO shaft. Release pull 
collar and continue to push driveline yoke forward 
until pull collar locks in place. 

12. Push/pull on both ends of driveline to make sure it is 

secured to tractor and gearbox shafts.

Refer to Figure 1-24 on page 27:
When towing implements on public roads, use safety 
chain (#12) with tensile strength equal to or greater than 
gross weight of implement being towed. This will control 
the implement in the event the hitch pin is lost. 

After attaching safety chain (#12) to the tractor, make a 
trial run by driving tractor to the right and to the left for a 
short distance to check safety chain length. If necessary, 
re-adjust chain length to eliminate a tight or loose chain. 
Make sure chain hook is securely locked in place.

1.

Route hydraulic hose (#8) through spring hose 
loop (#6) and attach to tractor hydraulic outlet.

2.

If cutter is provided with a CV driveline, route 
hydraulic hose beneath trunnion support (#1).

IMPORTANT: Always store parking jack on the deck 
storage holder and not on the hitch. Storing parking 
jack on the hitch can damage the jack.