Справочник Пользователя для Land Pride rcfm3696

17

12/15/15

The following pages are Assembly & Set-Up Instructions 
for Semi-Mount cutters. See “3-Point Assembly & Set-
Up” on page 12 and “Pull-Type Assembly & Set-Up” on 
page 22.

Refer to Figure 1-12:
1.

Attach mounting bracket (#1) with 3/4"-10 x 1 1/2" 
GR5 cap screw (#3) and lock nut (#4) to the right-
hand clevis as shown. Tighten nut to the correct 
torque.

2.

Attach spring hose loop (#6) to mounting bracket (#1) 
with 3/8"-16 x 1" GR5 cap screw (#2), flat 
washer (#5), and lock nut (#4). Tighten nut to the 
correct torque.

35006

1.

There are several cylinder mounting lugs (#3) that 
can be installed on axle (#2). Refer to NOTES IN 
BOLD in Figure 1-11 to make sure your cutter is 
equipped with the correct mounting lug and that the 
notch in the lug is located on the axle properly. See 
your nearest Land Pride dealer if it is not correct.

2.

Install washers (#5) as follows:

Install two 2 1/4" O.D. machine washers (#5) onto 
each tailwheel spindle (#7).

Install one special 4" O.D. harden washer (#5) onto 
each tailwheel spindle (#7).

3.

Insert tailwheel spindle (#7) into pivot tube on end of 
tailwheel arm (#1).

4.

Install 2 1/4" O.D. machine washers (#5) over each 
tailwheel spindle (#7) and secure with 3/8" x 2 1/2" 
roll pins (#6).

5.

Tail wheel arms (#1) should be adjusted to customer 
preference. When completed, they should be equal 
distance from center line of hydraulic lift cylinder.

a. Loosen hex flange lock nuts (#4) and adjust 

tailwheel arms (#1) in or out to desired locations.

b. Retighten lock nuts (#4) to the correct torque.

NOTE:  If preferred, rear guards may be assembled 
before the tailwheels. See “Assembly of Optional 
Equipment” on page 28 for rear guard instructions.

35027

33948