Справочник Пользователя для Uniden GH 200

GH130 Only

See manual 311845 for pump repair instructions

1. Flush pump.
2. Relieve pressure, page 7.

3. (Fig. 7) Remove suction tube (114) and paint hose (63) 

(remove at swivel end).

4. (Fig. 8) Push retaining ring (120) up; push out pin (92).

5. (Fig. 9). Loosen jam nut (86). Unscrew pump (111).

1. (Fig 10) Screw jam nut (86) to bottom of pump (111) 

threads. Screw pump (111) completely into manifold. 
Unscrew pump (111) from manifold until pump outlet 
aligns with hose. Hand tighten jam nut (86), then tap 1/8 
to 1/4 turn with hammer or torque to 75 ft-lb (101 N·m). 

2. (Fig. 11) Slowly pull engine starter rope until pump rod pin 

hole is aligned with hydraulic rod hole. Fig. 8. Push pin (92) 
into hole. Push retaining ring (120) into groove.

3. (Fig. 12) Fill packing nut with Graco TSL.

WLD





TIB

92

120

WLF

86

If pin (92) works loose, parts could break off and project 
through the air, resulting in serious injury or property dam-
age. Make sure pin is properly installed.

If the pump jam nut (86) loosens during operation, the 
threads of the bearing housing and drive train will be dam-
aged. Tighten jam nut (86) as specified.

WLG

86

111

TIE

120

92

WLI