Справочник Пользователя для Poulan 140603

7

02085

02342

02335

1.    Align mark on seal with mark at cover opening.
2.    Work seal into opening so cover sits between fl anges 

of seal.

1.    Raise your tractor mower deck to its highest position.
2.   Install the hex bolt, and locknut through mower deck 

baffl e and tighten securely.

IMPORTANT: ON TRACTORS WITH FUEL TANK UNDER THE 
SEAT, THE DRAWBAR MUST BE REMOVED FOR INSTALLATION 
OF MOUNTING BRACKET. TO REMOVE DRAWBAR, REMOVE 
TWO HEX BOLTS ON BOTH SIDES OF DRAWBAR.

1.    Assemble the mounting bracket, lanced tabs towards 

bottom, using the four smaller inside holes on the 
drawbar.

NOTE: If your tractor drawbar does not have the four correct 
holes for mounting the bracket, refer to the PREP A RA TION 
sec tion of this man u al.
2.    Install the four bolts and locknuts as shown and tighten 

securely.

3.   If drawbar was removed from tractor, reassemble to 

tractor at this time.  Tighten securely.

NOTE: If your tractor already has four (4) shoulder bolts 
installed on the rear draw bar, simply hang the mounting 
bracket, lanced tabs towards bottom, on the bolts. Discard  
hardware group "B" and disregard the remaining Step 2 
instructions.

02

33

7

If your tractor does not have four (4) shoulder bolts installed 
on the drawbar, follow the instructions below.

Only one set of hardware in GROUP "B" will be used to 
mount the rear mounting bracket.  To determine which set 
is correct for your tractor, check to see if there are (2) two 
upper corner ribs on each side of drawbar.  If your tractor 
has the upper corner ribs, use the (4) four self tapping 
shoulder bolts. If your tractor does not have the corner ribs, 
use the set of (4) four bolts and locknuts.

SELF TAPPING SHOULDER BOLTS (See Fig. 2B)
1.    Using the four formed holes in the drawbar, install the 

four shoulder bolts as shown and tighten securely.

2.      Hang the mounting bracket, lanced tabs towards bottom, 

on the bolts.

02

33

6