Справочник Пользователя для Multiquip GB12BP

1.  Before raising the mast, make sure the T-handle bolt 

lock is securely tightened. This will prevent the balloon/

lamp assembly from falling off. 

2.  Raise extension pole to desired height. Watch out for 

any overhead obstructions.

3.  Tighten extension clamp bolt securely. 

ALWAYS make sure 

the area above the 

lighting system is open 

and clear of overhead 

power lines  and other 

obstructions. The mast 

extends in excess of 

13 ft. (4 meters) when 

an optional extension 

is used. Contact with 

overhead power lines 

or other obstructions 

could result in equipment 

damage,  serious Injury 

or death!

When raising mast, 

be on the lookout for overhead 

obstructions such as high voltage 

power lines. The possibility exists 

of electrocution, even death if the 

lighting system comes in contact 

with high voltage power lines.

1.  If using a portable generator, start the generator as 

referenced in the "Start-up Section" of the supplied 

generator manual.

2.  Once the generator has started, plug the AC power 

cord from the lamp into a GFCI receptacle on the 

generator.

3.  If using a power source (Figure 34) other than a 

portable generator, plug the  AC power cord from the 

lamp into a 120 VAC, 60 Hz receptacle that is protected 

by a at least a 15 amp circuit breaker.

EXTERNAL

SINGLE-PHASE

(120 VAC)

POWER SOURCE

POWER CABLE

RECEPTACLE

Refer to previous sections on Applying Power 

(GB12BW), Dimming the Lamp, and Shutdown for 

procedures in operating the lamp.