Справочник Пользователя для Snapper 7800374
Axion / 150Z Series
TP 300-5412---ZT-SN
8/2008
6
Quick Setup List
Page
Setup Procedure
Steps to Perform
7
Uncrating
❏ Remove crate & banding.
❏ Place transmissions in ROLL RELEASE position & roll off
❏ Place transmissions in ROLL RELEASE position & roll off
skid.
8
Battery Activation &
❏ Charge the battery
(Note: proceed with other setup steps
Installation
while battery is charging).
❏ Install & secure battery.
9-13
Mower Assembly
❏ Install the seat.
❏ Install the seat safety switch.
❏ Set up the ground speed control levers.
❏ Torque the mower blade hardware.
❏ Install the seat safety switch.
❏ Set up the ground speed control levers.
❏ Torque the mower blade hardware.
14
Check Fluid Levels
❏ Fill & check Engine oil level.
❏ Reduce & check tire pressures
❏ Reduce & check tire pressures
(Front tires 18-20 psi, rear tires 10-12 psi).
15
Lubrication
❏ Lubricate all grease & oil points.
16
Burnish PTO Clutch
❏ Burnish PTO clutch
(run for 15 seconds, repeat 10 times)
.
16
SAFETY CHECKS
❏ Perform SAFETY INTERLOCK SYSTEM CHECK.
❏ Perform MOWER BLADE STOPPING CHECK.
❏ Perform MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)