Справочник Пользователя для Snapper EYZ15334BVE

 

a.  Squeeze the deck lift handle and the release 
lever and lift the deck lift handle until it locks in the 
top notch which is the high cut/transport position. 
b.  Remove retaining knobs located at the corners 
of footrest. Remove footrest. See Figure 3.3. 
c.  Check mower belt. If belt is frayed, slit, severed 
or belt strands exposed, replace belt before 
operating mower. 
d.  Reinstall footrest cover and reinstall knobs and 
tighten securely. 

 

 

 
 
 

The idler and spring provide proper belt tension 
and require no adjustment. If belt is frayed, slit, 
severed or belt strands exposed, replace belt 
before operating mower. 

The transaxle drive belts require no adjustment. 
If belts are frayed, slit, severed or belt strands 
exposed, replace belt before operating mower. 

 
3.3  SERVICE - EVERY 25 OPERATING HOURS 

Perform all service required after the first 5 hours of 
operation. Refer to Section “SERVICE – AFTER 5 
HOURS”. 
3.3.1. CHECK 

1.  Engine Cooling System 
The engine cooling system consists of an engine 
shroud and engine fins. These should be kept clean 
and free of debris as needed or cleaned. 
2. Engine Oil 
Change engine oil. Refer to Section “CHANGE 
ENGINE OIL”.  Refer to engine owner’s manual for 
oil specifications. 
3. Oil Filter 
Change engine oil filter. Refer to engine owner’s 
manual for filter specifications. 
4. Fuel Filter 
Refer to engine owner’s manual for service 
instructions. 
5. Air Filter 
Refer to engine owner’s manual for service 
instructions. Change air filter. Pull up and rotate the 
air cleaner latch to remove cleaner cover. See 
Figure 3.4. 

 

IMPORTANT: When cover is removed, you are 
viewing the carburetor side of the air filter, which will 
appear clean. Remove filter and pre-cleaner for 
inspection.