Справочник Пользователя для Snapper EYZ15334BVE

 

 

4.3.9.  MOWER DECK TIMING ROD  
The mower deck timing rod is pre-adjusted at the 
factory.  It is set to maintain the deck in the same 
attitude through all heights of cut. If the timing rod 
requires adjustment, contact an authorized SNAPPER 
dealer for service. 

4.3.10.  WHEEL BRAKE ADJUSTMENT  
Adjust the wheel brake if wheels turn when parking 
brake is engaged. Adjust the wheel brake by turning 
wheel brake adjusting nut clockwise to increase 
braking action or counter clockwise to decrease 
braking action. See Figure 4.11. 

 

4.4.1.  BLADE WEAR LIMITS 
1.  Inspect blade frequently for signs of excessive wear 
or damage. See Figure 4.12. 
 
4.4.2. BLADE 

1.  Make sure fuel cap is on tight. Turn fuel shut off 

valve (If equipped) to the “CLOSED” position. Start 
engine and allow it to run until engine runs out of 
fuel. Close vent on fuel filler cap. Refer Figure 2.3. 

2.  Remove key from ignition switch. 
3.  Remove spark plug wire(s) and secure away from 

spark plug(s). 

4.  Carefully stand YARD CRUISER on rear bumper. 
5.  Remove blade(s).  See Figure 4.14. 
6.  Inspect condition of blade.  See Figure 4.12. 
7.  Check blade balance after sharpening. If 

necessary, correct blade balance by grinding the heavy 
end of blade. 

 

 

8.  If blade is in good condition, sharpen at 22 to 28 
degrees. DO NOT sharpen beyond existing cutting 
edge.  See Figure 4.13. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

9. Reinstall blade. See Figure 4.14. Torque blade 
mounting bolts to recommended range of: 
33” Deck - 30 to 40 ft. lbs.