Справочник Пользователя для Euro-Pro V1730H

Your Cordless Sweeper will require very little assembly. You should remove it from 
the carton and familiarize yourself with all the components listed per the exploded 
view drawing (pg. 2) This will help you in the assembly and operation of your 
cordless sweeper.

Note: The charging adapter is shipped inside the dust cup.

Insert into Lower 
Handle

Fig. 3

Lower Handle

Fig. 2

1.

In the event that the edging tool is not attached to the sweeper, insert the edging 
tool into the "square" hole under the bottom of the sweeper power head. Gently 
but firmly push until the edging tool locks into place. (Fig. 1)

2.

Insert the lower handle  - small end - into the sweeper power head. 
Push until firmly in place. (Fig. 2)

3.

Attach the telescoping tube to the extension tube 
by pushing the plastic insert into
the bottom part of the telescopic pole. 
(Fig. 3a) Push in until the "tab" on the 
plastic insert snaps into the open 
slot on the telescopic tube. 
Push the  telescoping tube 
into the upper handle. (Fig. 3)
Insert the extension tube into the 
lower handle so that the “tab” on the 
plastic insert snaps into the open 
slot on the lower handle. (Fig. 3b) 

4.

Place the handle into the upward 
storage position.

5.

Plug the charging adapter into the 
sweeper power head charging jack.
Plug the charging adapter cord 
into a standard electrical outlet 
(120V, 60Hz.) The red charging 
indicator should illuminate or flash. If 
it does not, depress the On/Off switch 
one time.

Fig. 1

Fig. 3a

Fig. 3b

If uncertain as to how to remove your battery pack,  we         
suggest you take your sweeper to a reputable small 
appliance service technician to have this service performed.

Follow these steps when battery removal is required. 

This sweeper is equipped with Ni-Cd batteries and you need to dispose of them 
properly. When the batteries are no longer good for use, they must be removed from 
the sweeper for disposal. Do not remove the batteries for any reason other than 
disposal of them. The batteries must be recycled or disposed of in accordance 
with local regulations. Please consult your Yellow Pages or local recycling 
center for more information.

1.

Remove the extention handle and dust cup container.

2.

Turn unit over so that the base is facing upwards. Be careful not to turn the unit 
ON. (Fig. 16)

3.

Push in locking tab and lift off battery assembly. (Fig. 17)

4.

Place battery assembly aside.

5.

Insert the new battery assembly into unit. Ensure that locking tab snaps in place.

WARNING:

You must never use ordinary batteries for replacement as these 
may leak and cause damage. Use only battery pack X9730
for replacement.

Fig. 16

Fig. 17