Справочник Пользователя для Stiga EXCELLENT

See fig. 6. At the underside of the seat is a switch, 

which plays an important role in the machine’s 

safety system located.

Assemble the switch as follows:
1. Loosen the switch from the cables.
2. Assemble the switch at the underside of the seat 

with the screws (K).

3. Reconnect the cables to optional pins at the 

switch.

See fig. 7. Install the mounting in the rear (upper) 

holes as follows:
1. Install the shoulder washers (G) on the screws 

(H).

2. Insert the screws through the slots in the brack-

et. Place a washer (J) between the seat and the 

bracket.

3. Tighten the screws in the seat. Tightening 

torque: 9±1.7 Nm.

4. Check that the seat moves easily in the slots in 

the bracket.

Install the mounting in the front (lower) holes as 

follows:
1. Install a washer (J) on each knob (I).
2. Insert the knobs through the slots in the bracket 

and tighten by hand in the seat.

3. Fold the seat down and place it in the desired 

position.

4. Tighten the screw knobs (I) by hand.

The seat can be folded. If the machine is parked 

outside when it is raining, fold the seat forward to 

protect the seat cushion from getting wet.

See fig. 8, 9. The arm rests and the installation 

components are supplied in a separate box. Assem-

ble as follows:
1. Assemble the left and right mounts onto the 

seat. Use 3 screws (Q) supplied at each side.

2. Assemble the arm rests with screws (R), nuts 

(S) and spacers (T).

3. Tighten the screws so that the arm rests simply 

can be folded up/down.

See fig. 10. In order to minimise the axial play in 

the steering column, the shim washers (E) and/or 

(F) must be installed on the steering column be-

tween the steering column jacket and the bracket 

as follows.
1. Install the steering column jacket on the steer-

ing column and secure by knocking in the ten-

sion pin (D) approximately 1/3 of its length.

2. Pull the steering column jacket and the steering 

column up.

3. From the outside, check whether no washers, 

the 0.5 mm washer, the 1.0 mm washer or both 

washers can be inserted into the gap. The wash-

er/washers must not be forced in, as there must 

be a little axial play.

4. Pull out the cotter pin and dismantle the steering 

wheel jacket.

5. Install the washer/washers in accordance with 

point 3 above.

6. Install the steering column jacket on the steer-

ing column and secure by knocking in the ten-

sion pin fully. Use a counterhold.

See fig. 11. Screw the towing hitch (A) into the two 

holes on the underside of the rear axle using screws 

(B+C). Tighten the screws properly.

Tightening torque: 22 Nm.

Check the air pressure in the tyres. Correct air 

pressure:

For the installation of accessories, see separate in-

stallation guide supplied with each accessory.

Note: The cutting deck is regarded as an accessory 

here.