Справочник Пользователя для Radware VOYA-GRAND-MBK

Page  14

7075-166

September 25, 2012

R

1. 

Open both controls fully by rais-

ing the Burn Rate Air Control all the way up until it stops

and  PUSH  the  Start-up Air  Control  back  until  it  stops.

The blower tends to cool the appliance. Leave the blower

off until the burn is well established, i.e., 30 minutes.

2

. High Burn Setting:  Both controls are open.  Burn Rate 

Air Control is pulled up and the Start-up Air Control is

fully pushed in.  Blower may remain on.

3. 

Medium-High  Burn  Setting*:    Burn  Rate Air  Control

is closed then opened to 1 inch to fully open (pull up).  

Blower may remain on.

4. 

Medium-Low  Burn  Setting*:    Burn  Rate  Air  Control

is closed then opened to 1/4 inch to 1/2 inch (pull up).

Leave the blower off until the burn is well established, i.e., 

30 minutes.

5. 

Low  Burn  Setting*:    Burn  Rate Air  Control  is  closed

(down position).  Leave the blower off until the burn is 

well established, i.e., 30 minutes.
*NOTE: For burn settings 3 to 5 the Start-up Air Control

needs  to  be  pushed  in  (Open)  then  pulled  forward  to

activate the Automatic Combustion Control (ACC).
NOTE:  For maximum efficiency and lowest emissions,

when operating the blower in either the automatic or 

manual setting for the low and medium low burn settings 

leave the blower off until the burn is well established, i.e., 

30 minutes.

6.  The blower is equipped with a rheostat (speed control).

The  highest  blower  speed  is  obtained  by  turning  the

rheostat on, then adjusting back towards “OFF” as far

as  possible  without  turning  the  blower  off.    For  a  low

blower speed, turn the control knob clockwise as far as

possible

Blower Controls Under Ash Lip

MANUAL:  over-

rides the internal 

snap disc

AUTO:  Fan with turn ON/OFF 

automatically and is controlled 

by the internal Snap Disc

1.  The  blower  will  turn  on/off  automatically  when  set  to

AUTO.

2.  When set to MANUAL, the fan will turn on/off only when

you turn it on or off. This setting over-rides the internal

snap disc.

3.  Swing  the  grille  downward  to  expose  the  blower  con-

trols. Adjust the speed of the fan by turning the HIGH/

LOW knob to the desired setting.

NOTICE!
Do NOT operate a circulating fan within close proxim-

ity, approximately 4 ft (1.2m), of appliance

 • Can reverse air flow, blowing hot air into appliance

cavity.

 • Can damage appliance blower due to overheating.