Справочник Пользователя для Radware VOYA-GRAND-MBK

Скачать
Страница из 56
Page  18
7075-166
September 25, 2012
R
VOYAGEUR GRAND Wood Insert
•  Frequency: As desired
•  By: Homeowner
•  Clean glass with a non-abrasive glass cleaner. Abrasive
cleaners may scratch and cause glass to crack.
•  If the deposits on the glass are not very heavy, normal 
glass  cleaners  work  well.  Heavier  deposits  may  be
removed by using a damp cloth dipped in wood ashes or 
by using a commercially available oven cleaner.  
•  After using an oven cleaner, it is advisable to remove any
residue with a glass cleaner or soap and water. Oven
cleaner  left  on  during  the  next  firing  can  permanently
stain  the  glass  and  damage  the  finish  on  plated  metal
surfaces.
•  A portion of the combustion air entering the firebox is de-
flected down over the inside of the door glass.
•  This air flow “washes” the glass, helping to keep smoke
from adhering to its surface.    
•  When operated at a low burn rate, less air will be flowing
over the glass and the smoky, relatively cool condition of
a low fire will cause the glass to become coated.
Operating the appliance with the Burn Rate Air Control
and Start-Up Air Control all the way open for 15-20 min-
utes should remove the built up coating.  
E. Glass Cleaning
CAUTION! Handle glass assembly with care. Glass is 
breakable
.
•  Avoid striking, scratching or slamming glass
•  Avoid abrasive cleaners
•  Do not clean glass while it is hot
Replace the firebrick if they become crumbly and/or if
there is a 1/4 inch (6.35mm) gap between the bricks.
The firebox is lined with firebrick, which has exceptional
insulating properties. Do not use a grate; simply build
a fire on the firebox floor. Do not operate appliance
without firebrick.
1.  After the coals have completely cooled, remove all
old brick and ash from unit and vacuum firebox.
2.  Remove new brick set from box and lay out to the
diagram shown in the instructions that come with 
the replacement brick set.
3.  Lay bottom bricks in unit.
4.  Install rear bricks on the top of the bottom bricks.
5.  Install side bricks. Slide top of brick under clips
on side of firebox and push the bottom of the brick
until it is flush with the side of the unit.
F.  Inspect Firebrick & Replacement
 Instructions
•  Frequency: After each ash removal
•  By: Homeowner
Use Part 832-0550 when ordering individual brick. Provide
brick dimension or copy the page in the service parts list, mark
the desired brick and take it to your authorized dealer.