Справочник Пользователя для Radware VOYA-GRAND-MBK

September 25, 2012

7075-166

Page  35

R

UL 1777 Insulated Stainless Steel 

Liner or Other Approved Lining System 

Follow Manufacturer’s Instructions 

on Insulation and Support 

For Zero or Other Non-Code Clearances, 

Follow Approved Liner Manufacturer’s Specific 

Insulation Requirements:  Different Clearances 

May Require Different Specifications 

Masonry Chimney Must 

Have Structural Integrity 

UL 1777 Insulated Stainless Steel 

Liner or Other Approved Lining System 

Minimum 8 in. (203mm) Masonry 

Thickness in Front of Smoke Chamber

Damper Plate Removed or 

Fastened in Open Position 

Seal with Non-Combustible Material 

Minimum Clearance in Accordance 

with Insert Listing 

Floor Protection in 

Accordance with Insert 

Listing 

Follow Manufacturer’s 

Instructions for Maximum 

Liner Extension Above 

Chimney 

Maximum 30

 

Degrees 

Offset in Chimney 

Combustible Floor 

NOTE: In Canada, this fireplace insert must be installed

with a continuous chimney liner of a 6 inch (152mm) diam-

eter extending from the fireplace insert to the the top of the

chimney.  
The chimney liner must conform to the Class 3 require-

ments of CAN/ULC-S635, Standard for Lining Systems for

Existing  Masonry  or  Factory-Built  Chimneys  and  Vents,

or CAN/ULC-S640, Standard for Lining Systems for New

Masonry Chimneys.

This  insert  conforms  with  the  UL  1482  and  ULC  S628

(Canada)  in  all  respects,  and  is  approved  to  UL  &  ULC

safety standards for installation and use within a fireplace

with a masonry chimney in accordance with NFPA 211 and

CAN/CSA-B365-01.