Справочник Пользователя для Multiquip CA4HC

3. Place the

 choke lever (Figure 18) in the "CLOSED " position

if starting a 

cold engine.

This section is intended to assist the operator with the initial
start-up of the walk-behind trowel.  It is extremely important that
this section be read carefully before attempting to use the trowel
in the field.

DO NOT use your trowel until this section is thoroughly
understood

1. Place the engine 

fuel valve lever (Figure 16) to the "ON"

position.

Extra care should be taken when lifting the trowel off the ground.
Serious damage to the machine or personal injury could be
caused by dropping a trowel.

5. Place the

 engine ON/OFF switch (Figure 20) in the "ON "

position.

NEVER attempt to lift this machine alone. NEVER lift the
trowel by the guard ring as it may rotate and cause injry.

Use only the manufacturer's approved lifting points. The
trowel may be lifted at the center lifting bale by crane or other
lifting device of adequate capacity.

4. Place the

 choke lever (Figure 19) in the "OPEN" position if

starting a 

warm engine or the temperature is warm.

2. Place the trowel's 

throttle lever (Figure 17) to the "IDLE"

position.

DO NOT attempt to operate the trowel until the Safety,
General Information and Inspection sections of this manual
have been read and  thoroughly understood.

IDLE

POSITION

THROTTLE

LEVER