Справочник Пользователя для McCulloch M19542H

•  Lift seat pan to raised position.
•  If this battery is put into service after month and year 

indicated on label (label located between terminals) 

charge battery for minimum of one hour at 6-10 amps. 

(See "BATTERY" in MAINTENANCE section of this 

manual for charging instructions).

NOTE: You may now roll your tractor off the skid. Follow 

the ap pro pri ate instruction below to remove the tractor 

from the skid.

  WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 

sure tractor is in a well-ventilated area. Be sure the area in  

front of tractor is clear of other peo ple and objects.

•  Raise attachment lift lever to its highest po si tion.
•  Release parking brake by de press ing clutch/brake 

ped al.

•  Place freewheel control in "trans mis sion dis en gaged 

position" (See “TO TRANS PORT” in the Op er a tion 

section of this manual).

•  Roll tractor forward off skid.
• 

Remove banding holding the deflector shield up against 

tractor.

Adjust seat before tightening adjustment knob.
•  Remove adjustment knob and flat washer securing 

seat to cardboard packing and set aside for assembly 

of seat to tractor.

• 

Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

•  Place seat on seat pan so head of shoulder bolts are 

positioned over the large slotted holes in pan.

•  Push down on seat to engage shoulder bolts in slots 

and pull seat towards rear of tractor.

•  Pivot seat and pan forward and as sem ble adjustment 

knob and flat washer loosely. Do not tighten.

•  Lower seat into operating position and sit in seat.
• 

Slide seat until a comfortable position is reached which 

allows you to press clutch/brake pedal all the way 

down.

•  Get off seat without moving its ad just ed position.
•  Raise seat and tighten adjustment knob securely.

02615

02617