Справочник Пользователя для Radware VOYA-GRAND-PMH

Page  10

7075-166

September 25, 2012

R

1. Start-Up Air Control
The function of the Start-Up Air Control is to activate the

Automatic Combustion Control system (ACC).
•  Push the Start-Up Air Control all the way back until it stops

and then pull forward to the front of the appliance until it 

stops. 

•  The air channel opens and allows air to enter the front of 

the appliance for approximately 20-25 minutes.

•  The air channel gradually shuts down until it is completely

closed at the end of the 20-25 minutes.

•  The fire is now controlled by the air supplied by the Burn

Rate Air Control.

•  This function should be performed each time you reload

the appliance.

•

The  air  supply  enters  at  the  upper  front  of  the  firebox,

near the top of the glass door. 

•

This preheated air supplies the necessary fresh oxygen

to mix with the unburned gases, helping to create the 

second, third and fourth combustion process.

•  This air is regulated by the Burn Rate Air Control.
•

There are four settings High, Medium-High, Medium-Low

and Low.

•

When the control is raised all the way up it is on the High

setting and when pushed all the down it is on the Low 

setting. 

Typically, when you build a fire, you open the air controls fully

and monitor the fire to prevent it from going into an overfire

situation and/or burning your wood up too quickly before you

shut down the air controls to the desired burn rate.  
When using the Automatic Combustion Control (ACC) system,

you do not have to continually monitor the fire. Once you

set the ACC system it will control the fire for you. Follow the

instructions below to learn how to operate your stove with 

ease.

For maximum operating efficiency 
1.  Burn dry, well-seasoned wood.
2.  Follow  these  burn  rate  instructions  below  and  refer  to

*NOTE:  These are guidelines. Actual settings may vary with type

of wood, chimney draft, altitude and other variables.

•

Open both controls fully by raising the Burn Rate Air Con-

trol all the way up until it stops and push the Start-up Air

Control back until it stops.

  

•  The blower tends to cool the appliance. Leave the blower

off until the burn is well established, i.e., 30 minutes.

•

After loading the appliance with wood and starting the fire,

set both controls to the desired setting by following the 

burn rate instructions below.

•  Raise the Burn Rate Air Control all the way up until it stops

(top marker) to a fully open position.

•

Push the Start-Up Air Control all the way back until it stops

and leave it there. 

•  This setting over-rides the timer system (ACC) so you must

monitor the fire closely while in this setting.

•

Raise the Burn Rate Air Control all the way up until it stops

to a fully open position.

•

Push the Start-Up Air Control all the way back until it stops

and then pull forward until it stops.

•  This activates the timer system (ACC).

•  Raise the Burn Rate Air Control up 1/4 from lowest posi-

tion.  

•

Push the Start-Up Air Control all the way back until it stops

and then pull forward until it stops.

•  This activates the timer system (ACC).

•  Leave the Burn Rate Air Control at its lowest position.
•

Push the Start-Up Air Control all the way back until it stops

and then pull forward until it stops. 

•  This activates the timer system (ACC).

Burn Rate Control

ACC Start-up 

Air Control

HIGH

LOW

To activate:  Push back until it stops 

and then pull forward until it stops