Справочник Пользователя для Radware VOYA-GRAND-PMH

September 25, 2012

7075-166

Page  43

R

The blower cord is shipped to be installed on the right side

of the appliance. You may relocate the cord so it is on the

left side. 
Overview:  You  are  removing  the  power  cord  from  the

blower controls, re-routing the cord to the left side and re-

installing the power cord to the blower controls.  Refer to 

the exploded drawing on 

page 44. 

1.  Remove contents from box being careful not to scratch or 

damage the cast trim pieces.

2. 

Lay surround pieces face down on a protected surface to 

prevent scratching

.

3.  Align the bosses on the top piece to the holes on the side

pieces. Secure the 3 pieces together.

4.  Attach the mounting brackets to the side pieces included with

the kit.

5.  In order to get a tight seal for the surround, you must reposition 

a side shield. There are two holes on the shield and it will come

from the factory secured in the first (left) hole. Remove the

shield and re-install using the second (right) hole. Figure 43.2.

5.  Position the trim on the appliance matching up the mounting 

brackets with the slots on the appliance.

6.  Attach the surround to the appliance 2 screws.

Included in Surround Kit: (2) side pieces, left and right; (1)

l top piece; (1) fastener package.
Tools Needed: Powered 4 to 6 inches long Phillips head 

screw driver; pliers

4 Mounting Brackets

Mounting 

Brackets

Attach to Appliance 

with Screws

Remove and Reposition 

Side Shield using Second 

Hole

1.  Swing the grille down to expose the 2 bolts, one

at each end.  Remove the bolts and pull blower 

access assembly away from appliance and store 

away from your work area.

2.  Remove the 2 screws in the hold down bracket in

front of the blower assembly. You do not need to

remove the blower from the hold down bracket.

3. Disconnect the 2 blower wires that are attached 

to the wire harness and pull the blower assembly 

away from the appliance.

Size: 40 in. W x 30 in. H