Справочник Пользователя для Ryobi RY34001

7 — English

If the button does not release completely in the 

positioning hole, the shafts are not locked into place.  
Slightly rotate from side to side until the button is locked 
into place.



  Tighten the knob securely.

Be certain the knob is fully tightened before operating 
equipment; check it periodically for tightness during use 
to avoid serious personal injury.

See Figure 3.


  Remove wing nut, washer, and bolt from the front 

handle.



   Install the front handle onto the top side of the drive shaft 

housing in the area indicated by the label.

  

NOTE: The open side of the handle should face the 
operator. 



  Place the bolt through the front handle.

 

NOTE: The hex bolt head fits inside the hex recess molded 
into one side of the handle.



  Reinstall the washer and wing nut.



  Tighten wing nut securely.

For removing or changing the attachment:


  Stop the engine and disconnect the spark plug wire.



  Loosen the knob.



  Push in the button and twist the shafts to unlock and 

separate.

Do not allow familiarity with product to make you care-
less. Remember that a careless fraction of a second is 
sufficient to inflict serious injury.

Always wear eye protection with side shields marked to 
comply with ANSI Z87.1, along with hearing protection. 
Head protection may also be required depending on the 
type of attachment used and as prescribed in the attach-
ment’s Operator’s Manual. Failure to do so could result in 
objects being thrown into your eyes and other possible 
serious injuries.

Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of 
attachments or accessories not recommended can result 
in serious personal injury.

Gasoline and its vapors are highly flammable and ex-
plosive. To prevent serious personal injury and property 
damage, handle it with care. Keep away from ignition 
sources and open flames, handle outdoors only, do not 
smoke and wipe up spills immediately.



  Clean surface around fuel cap to prevent contamination.



  Loosen fuel cap slowly by turning counterclockwise. Rest 

the cap on a clean surface.



  Carefully pour fuel into the tank. Avoid spillage.



  Prior to replacing the fuel cap, clean and inspect the 

gasket.



  Immediately replace fuel cap and hand tighten by turning 

it clockwise. Wipe up any fuel spillage.



  Move at least 30 ft. away from refueling area before starting 

the product.

NOTE:  It is normal for smoke to be emitted from a new 
engine after first use.

Always shut off engine before fueling. Never add fuel to a 
machine with a running or hot engine. Move at least 30 ft. 
from refueling site before starting engine. Do not smoke 
and stay away from open flames and sparks.  Failure to 
safely handle fuel could result in serious personal injury.