Справочник Пользователя для Great Dane GDRZ25KHE
Service Electrical - 23
SERVICE ELECTRICAL
Service Electrical
WARNING: Battery posts, terminals and related
accessories contain lead and lead components, chemicals
known to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
accessories contain lead and lead components, chemicals
known to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
Removing and Installing the Battery
Removing:
1. Park the vehicle safely. (See Parking Safely in the
safety section.)
safety section.)
MX9209
2. Slide black cover (A) away from the negative (-) battery
terminal and disconnect the negative (-) battery cable (B).
terminal and disconnect the negative (-) battery cable (B).
3. Slide red cover (C) away from the positive (+) battery
terminal and disconnect the positive (+) battery cable (D).
terminal and disconnect the positive (+) battery cable (D).
4. Loosen the cap screws and nuts (E) on both sides of the
battery tray.
battery tray.
5. Remove battery (F) and isolator pad (G).
Installing:
1. Place isolator pad (G) in the battery tray.
2. Install battery (F) in the battery tray, making sure that
the isolator pad (G) is between the bottom and sides of the
the isolator pad (G) is between the bottom and sides of the
battery tray.
3. Tighten the cap screws and nuts (E) to secure the
battery in the battery tray. Do not overtighten.
battery in the battery tray. Do not overtighten.
4. Connect the positive (+) battery cable (D) first, then the
negative (-) cable (B).
negative (-) cable (B).
5. Apply general purpose grease or silicone spray to the
terminals to prevent corrosion.
terminals to prevent corrosion.
6. Slide covers (A and C) over battery terminals.
Checking Battery Electrolyte Level
NOTE: Add only distilled water to replace normal
electrolyte loss.
electrolyte loss.
1. Park the vehicle safely. (See Parking Safely in the
safety section.)
safety section.)
2. Remove battery from vehicle and set it on a level
surface.
surface.
3. Remove battery cell caps. Make sure cap vents are not
plugged.
plugged.
MIF
4. Check electrolyte level. Electrolyte (A) should be
c
CAUTION: Avoid injury! The battery produces a
flammable and explosive gas. The battery may
explode:
explode:
•
Do not smoke near battery.
•
Wear eye protection and gloves.
•
Do not allow direct metal contact across
battery posts.
•
Remove negative cable first when
disconnecting.
•
Install negative cable last when connecting.
A
B
C
D
E
F
G
c
CAUTION: Avoid injury! Battery electrolyte
contains sulfuric acid. It is poisonous and can
cause serious burns:
cause serious burns:
•
Wear eye protection and gloves.
•
Keep skin protected.
•
If electrolyte is swallowed, get medical
attention immediately.
•
If electrolyte is splashed into eyes, flush
immediately with water for 15-30 minutes and
get medical attention.
get medical attention.
•
If electrolyte is splashed onto skin, flush
immediately with water and get medical
attention if necessary.
attention if necessary.
B
A
C