Справочник Пользователя для Husqvarna 230 ACX

 

18 - English

 

1.

If the lawn in the proposed working area is taller 
than 10 cm, mow it using a normal lawn mower. 
Then collect the clippings.

2.

Read carefully through all the steps before the 
installation.

3.

Check that all parts for the installation are 
included:

The numbers in brackets refer to the detail 
diagram 

 

 on 

page 11.

• Operator’s Manual (26)

• Automower

• Charging station (15)

• Loop wire for the boundary wire and guide wire 

(18)

• Transformer (19)

• Low voltage cable (20)

• Staples (21)

• Connector for the loop wire (22)

• Nails (23)

• Measurement gauge (24)

• Solderless coupler for the loop wire (25)

During installation you will also need: A hammer to 
knock the staples into the ground, combination pliers, 
and a straight spade if the boundary wire is to be 
buried.

 

For examples of good positioning of the charging 
station, see 

 

 on page 63.

If you are going to install a guide wire, read 

 

, see page 33, before 

choosing the position of the charging station.

The charging station must be positioned with a great 
deal of free area in front of it (at least 3 metres). It 
should also be positioned centrally in the working 
area so that Automower can easily find the charging 
station and quickly reach all parts of the working area.

It is a good idea to place the charging station in the 
shadow. The battery is spared if it is charged in the 
lowest possible ambient temperature.

3012-512

3012-510