Справочник Пользователя для Husqvarna 230 ACX

English - 33

The guide wire is an extra wire that is laid from the 
charging station, out towards a remote part of the 
working area or through a narrow passage and is then 
connected to the boundary wire. The same wire used 
for the boundary wire is also used for the guide wire.

Up to two guide wires can be installed for 230 ACX. In 
similarity to the boundary wire, the guide wire can 
either be stapled down or buried. 

When a guide wire is installed, Automower can also be 
set to follow the guide wire out from the charging 
station using the function Follow loop out (3-2-1), see 
page 51.

The guide wire may be necessary in installations 
where the search methods Irregular and Follow 
boundary wire are not adequate for the mower to 
quickly and easily find the charging station.

A few examples of installations where a guide wire is 
recommended follow below:

•

Narrow passages.

In passages where the distance between the 
boundary wires is less than 3 metres, it is 
recommended to install a guide wire through the 
passage. This is a better solution than allowing 
Automower to follow close to the boundary wire by 
setting a low Corridor width value.

•

The boundary wire runs along a steep slope 
(steeper than 25 %).

When Automower follows the boundary wire that 
runs along a steep slope, the mower will change 
direction and run away from the boundary wire.

•

Numerous or large islands.

If Automower is permitted to follow the boundary 
wire it may circle an island roughly twice before it 
leaves the island and once again searches for 
the boundary wire.

 3012-736